105210-6230 ZEXEL 9 440 610 268 BOSCH SUPPLY PUMP 9440610268 1052106230 225602310a


 

Information supply pump

BOSCH 9 440 610 268 9440610268
ZEXEL 105210-6230 1052106230
HINO 225602310A 225602310a
105210-6230 SUPPLY PUMP
Rating:
13
Buy SUPPLY PUMP 105210-6230 zexel genuine, new aftermarket engine parts with delivery

Scheme ###:

1. [1] 152061-0020 PUMP HOUSING
2. [1] 152030-0300 STOP PIN
5. [1] 152100-2301 PUMP PLUNGER
6. [1] 152102-1300 COMPRESSION SPRING
7. [1] 152105-1500 CAPSULE
8. [1] 139526-0000 GASKET
14. [2] 152115-0500 VALVE BODY
14. [2] 152115-0500 VALVE BODY
15. [2] 152116-0200 COILED SPRING
15. [2] 152116-0200 COILED SPRING
16. [1] 152117-0620 CAPSULE
18. [2] 029631-6060 O-RING
18. [2] 029631-6060 O-RING
25. [1] 152200-6720 HAND PRIMER
30. [1] 152300-7020 EYE BOLT
32. [1] 029731-4080 EYE BOLT
33. [1] 152350-8300 PIPE
35. [2] 139514-0300 GASKET
36. [2] 139514-0300 GASKET

Cross reference number

Zexel num
Bosch num
Firm num
Name
105210-6230 
9 440 610 268 
NP-FP/KEP-AD 
225602310A  HINO
SUPPLY PUMP
K 14GC FEED PUMP F/P




Information:

Cautions Regarding Battery* Handle Battery Carefully * Never use flames or allow sparks near the battery. The battery releases flammable hydrogen gas and oxygen gas. These gases can be ignited by flames and cause an explosion.* Do not use the battery when the fluid surface is lower than the minimum level. Using a battery with a low electrolyte level can result in an explosion.* Do not short the battery terminals with a tool or other metal object.* When disconnecting battery cables, always remove the cable from the negative (-) terminal first. When reconnecting cables, attach the cable to the positive (+) terminal first.* Charge the battery in a well-ventilated area, with all filling hole plugs removed.* Make sure the cable clamps are securely installed on the battery terminals. A loose cable clamp can cause sparks that may result in explosion.* Before servicing electrical components or conducting electrical welding, set the battery switch to the [Open/OFF] position or disconnect the cable from the negative (-) battery terminal to cut off the electrical current.* Electrolyte (battery fluid) contains dilute sulfuric acid. Careless handling of the battery can lead to the loss of sight and/or burns. Also, do not swallow electrolyte.* Wear protective goggles and rubber gloves when maintaining and inspecting the battery (when adding water, charging, etc.).* If electrolyte is spilled onto the skin or clothes, immediately wash with lots of clean fresh water and thoroughly clean with soap.* If electrolyte gets into eyes, immediately flush with lots of clean fresh water and seek immediate medical attention.* Should you accidentally swallow electrolyte, gargle with plenty of water, then drink lots of water, and seek immediate medical attention.
Response To Abnormalities* If Engine Overheats, Conduct Heating Operation Before Stopping The Engine If the engine overheats, do not stop the engine immediately. Abruptly stopping an overheated engine may cause the coolant temperature to rise, resulting in seizing of the engine. If the engine overheats, operate the engine at low idling speed (cooling temperature), and stop the engine after the coolant temperature lowers sufficiently.Do not add coolant immediately after stopping the engine. Adding coolant to a hot engine may cause damage to the cylinder heads due to sudden change in temperature. Add coolant after the engine cools to room temperature.* If Engine Stops Due To Abnormality, Exercise Caution When Restarting If the engine stops due to an abnormality, do not restart the engine immediately. If the engine stops with an alarm, check and correct the cause of the problem before restarting. Operating the engine without correcting the problem may result in serious engine problems.* If Oil Pressure Drops, Stop Engine Immediately If the engine oil pressure decreases, stop the engine immediately, and inspect the lubrication system. Operating the engine with low oil pressure may cause seizing of the bearings and other parts.* If Fan Belt Breaks, Stop Engine Immediately If the fan belt breaks, stop the engine immediately. Continued operation of the engine without the fan belt causes coolant to change to steam and

Have questions with 105210-6230?





Group cross 105210-6230 ZEXEL

Isuzu 

9 440 611 043 
8971315200 
SUPPLY PUMP
9 440 610 432 
NP-FP/KEP-A 
8971265200 
SUPPLY PUMP
9 440 610 291 
NP-FP/KEP-A 
1157501550 
SUPPLY PUMP

Hino 

105210-6230  
9 440 610 268 
NP-FP/KEP-AD 
225602310A 
SUPPLY PUMP
9 440 610 166 
 
SUPPLY PUMP

Isuzu 

9 440 610 849 
NP-FP/KEP-A 
1157501560 
SUPPLY PUMP
9 440 610 254 
NP-FP/KEP-AD 
 
SUPPLY PUMP

Isuzu 

9 440 610 141 
NP-FP/KEP-A 
8971159711 
SUPPLY PUMP
9 440 610 153 
NP-FP/KEP-A 
 
SUPPLY PUMP
9 440 610 261 
 
SUPPLY PUMP
Back to top