130501-0200 ZEXEL 9 411 610 260 BOSCH SLIDING PIECE 9411610260 1305010200 5157291420


 

Information sliding piece

BOSCH 9 411 610 260 9411610260
ZEXEL 130501-0200 1305010200
ISUZU 5157291420 5157291420
130501-0200 SLIDING PIECE
Rating:
19
Buy SLIDING PIECE 130501-0200 zexel genuine, new aftermarket engine parts with delivery

Cross reference number

Zexel num
Bosch num
Firm num
Name
130501-0200 
9 411 610 260 
5157291420  ISUZU
SLIDING PIECE
C 14FK SLEEVE parts(S-K) Others
130501-0200 
9 411 610 260 
16786Z9000  NISSAN-DIESEL
SLIDING PIECE
C 14FK SLEEVE parts(S-K) Others
130501-0200 
9 411 610 260 
1312960790  ISHIKAWAJIMA-S
SLIDING PIECE
C 14FK SLEEVE parts(S-K) Others




Information:

Caterpillar does not recommend checking actual engine bearing clearances, particularly on small engines, because of the possibility of obtaining inaccurate results, and the possibility of damaging the bearing or journal surfaces. Each Caterpillar engine bearing is quality checked for specific wall thickness. If the crankshaft journals and bores for the block and rods were measured at disassembly and found to be within specifications, no further checks are necessary when using the correct bearings. However, if the serviceman still wants to measure the bearing clearances, Plastigage is an acceptable method. Plastigage is less accurate on small diameter journals where clearances are less than 0.10 mm (0.004 in).
Lead wire, shim stock or a dial bore gauge can damage the bearing surfaces.
1. The serviceman must be very careful to use Plastigage correctly, the following points must be remembered:a. Make sure that the backs of the bearings and the bores are clean and dry.b. Make sure that the bearing locking tabs are properly seated in their slots.c. The crankshaft must be free of oil where the Plastigage touches it.d. If the main bearing clearances are checked with the engine upright or on its side, the crankshaft must be supported. Use a jack under an adjacent crankshaft counterweight and hold the crankshaft against the crown of the bearing. If the crankshaft is not supported, the weight of the crankshaft will cause incorrect readings.e. Put a piece of Plastigage on the crown of the bearing half that is in the cap. Do not allow the Plastigage to extend over the edge of the bearing.f. Install the bearing cap using the correct torque-turn specifications. Do not use an impact wrench. Be careful not to dislodge the bearing when the cap is installed.g. Do not turn the crankshaft with the Plastigage installed. h. Carefully remove the cap but do not remove the Plastigage. Measure the width of the Plastigage while it is in the bearing cap or on the crankshaft journal, See photograph.i. Remove all the Plastigage before reinstalling the cap. When using Plastigage, the readings can sometimes be unclear. For example, all parts of the Plastigage are not the same width. Measure the major width to make sure they are within the specification range.

Have questions with 130501-0200?





Group cross 130501-0200 ZEXEL

Isuzu 

130501-0200  
9 411 610 260 
5157291420 
SLIDING PIECE

Nissan-Diesel 

130501-0200  
9 411 610 260 
16786Z9000 
SLIDING PIECE

Ishikawajima-S 

130501-0200  
9 411 610 260 
1312960790 
SLIDING PIECE
Back to top