Buy 150650-2200 ZEXEL 9 431 611 194 BOSCH NOZZLE-RETAINING NUT 9431611194 1506502200 236331010a


 

Information nozzle-retaining nut

BOSCH 9 431 611 194 9431611194
ZEXEL 150650-2200 1506502200
HINO 236331010A 236331010a
150650-2200 NOZZLE-RETAINING NUT
Rating:
19
Buy NOZZLE-RETAINING NUT 150650-2200 zexel genuine, new aftermarket engine parts with delivery

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below
 
£15.08
 

06 Mar 2018

Bosch: Bosch
Bosch 9431611194 Nozzle Retaining Nut

Include in ###:

Number on scheme 20
NOZZLE-RETAINING NUT
1050304260 as NOZZLE-RETAINING NUT

Cross reference number

Zexel num
Bosch num
Firm num
Name
150650-2200 
9 431 611 194 
236331010A  HINO
NOZZLE-RETAINING NUT
A C 53PZ RETAINING NUT NH parts NH




Information:

It is not necessary to remove the oil pan.1. Remove the coolant from the cooling system.2. Use tooling (A) and remove oil filter (2). 3. Loosen clamps (1) and disconnect the bases.4. Remove bolt (4) and three bolts from behind the oil cooler. 5. Remove oil filter base and engine oil cooler (3) as a unit.Install Engine Oil Cooler And Oil Filter Base
1. Inspect the O-ring seals in the oil filter base. Install new seals if needed. Put oil on the seal. 2. Put oil filter base and oil cooler (1) in position on the engine.3. Install the four bolts that hold the oil cooler in place. 4. Connect the two hoses and install clamps (2).5. Install oil filter (3). See the instructions on the oil filter.Disassemble Engine Oil Cooler And Oil Filter Base
start by:a) remove engine oil cooler and oil filter base1. Remove bolts (1) and make a separation of cover (2) from the oil filter base. 2. Remove nuts (3) and make a separation of the oil cooler from oil filter base (4). 3. Remove divider (6) from oil cooler (5). 4. Remove plug (9), spring (8) and bypass valve (7). 5. Remove plug (12), spring (11) and bypass valve (10) from the oil filter base. Assemble Engine Oil Cooler And Oil Filter Base
1. Put valve (1) and spring (2) in position in oil filter base (4). 2. Install plug (3).3. Put the valve and spring (5) in position and install plug (6). 4. Put divider (7) in position between the fifth and sixth plates from the flange and on the same end as the short stud. 5. Install oil filter base (4) in position on oil cooler (8) and install the nuts. Tighten the nuts to a torque of 22 3 N m (16 2 lb.ft.).6. Install the gasket, cover (9) and the bolts. end by:a) install engine oil cooler and oil filter base

Have questions with 150650-2200?





Group cross 150650-2200 ZEXEL

Hino 

150650-2200  
9 431 611 194 
236331010A 
NOZZLE-RETAINING NUT
Back to top