105101-7704 ZEXEL 9 430 612 837 BOSCH NOZZLE AND HOLDER ASSY. 9430612837 1051017704 236002663b


 

Information nozzle and holder assy.

BOSCH 9 430 612 837 9430612837
ZEXEL 105101-7704 1051017704
HINO 236002663B 236002663b
105101-7704 NOZZLE AND HOLDER ASSY.
Rating:
83
Buy NOZZLE AND HOLDER ASSY. 105101-7704 zexel genuine, new aftermarket engine parts with delivery

Cross reference number

Zexel num
Bosch num
Firm num
Name
105101-7704 
105101-7705 
9 430 612 837 
236002663B  HINO
NOZZLE AND HOLDER ASSY.
J-2 * K




Information:

Cautions Regarding Battery* Handle Battery Carefully * Never use flames or allow sparks near the battery. The battery releases flammable hydrogen gas and oxygen gas. These gases can be ignited by flames and cause an explosion.* Do not use the battery when the fluid surface is lower than the minimum level. Using a battery with a low electrolyte level can result in an explosion.* Do not short the battery terminals with a tool or other metal object.* When disconnecting battery cables, always remove the cable from the negative (-) terminal first. When reconnecting cables, attach the cable to the positive (+) terminal first.* Charge the battery in a well-ventilated area, with all filling hole plugs removed.* Make sure the cable clamps are securely installed on the battery terminals. A loose cable clamp can cause sparks that may result in explosion.* Before servicing electrical components or conducting electrical welding, set the battery switch to the [Open/OFF] position or disconnect the cable from the negative (-) battery terminal to cut off the electrical current.* Electrolyte (battery fluid) contains dilute sulfuric acid. Careless handling of the battery can lead to the loss of sight and/or burns. Also, do not swallow electrolyte.* Wear protective goggles and rubber gloves when maintaining and inspecting the battery (when adding water, charging, etc.).* If electrolyte is spilled onto the skin or clothes, immediately wash with lots of clean fresh water and thoroughly clean with soap.* If electrolyte gets into eyes, immediately flush with lots of clean fresh water and seek immediate medical attention.* Should you accidentally swallow electrolyte, gargle with plenty of water, then drink lots of water, and seek immediate medical attention.
Response To Abnormalities* If Engine Overheats, Conduct Heating Operation Before Stopping The Engine If the engine overheats, do not stop the engine immediately. Abruptly stopping an overheated engine may cause the coolant temperature to rise, resulting in seizing of the engine. If the engine overheats, operate the engine at low idling speed (cooling temperature), and stop the engine after the coolant temperature lowers sufficiently.Do not add coolant immediately after stopping the engine. Adding coolant to a hot engine may cause damage to the cylinder heads due to sudden change in temperature. Add coolant after the engine cools to room temperature.* If Engine Stops Due To Abnormality, Exercise Caution When Restarting If the engine stops due to an abnormality, do not restart the engine immediately. If the engine stops with an alarm, check and correct the cause of the problem before restarting. Operating the engine without correcting the problem may result in serious engine problems.* If Oil Pressure Drops, Stop Engine Immediately If the engine oil pressure decreases, stop the engine immediately, and inspect the lubrication system. Operating the engine with low oil pressure may cause seizing of the bearings and other parts.* If Fan Belt Breaks, Stop Engine Immediately If the fan belt breaks, stop the engine immediately. Continued operation of the engine without the fan belt causes coolant to change to steam and

Have questions with 105101-7704?





Group cross 105101-7704 ZEXEL

Hino 

9 430 612 941 
236002660A 
NOZZLE AND HOLDER ASSY.
J-2
9 430 611 626 
30-3570H 
236002661A 
NOZZLE AND HOLDER ASSY.
J-2
9 430 612 951 
236002662A 
NOZZLE AND HOLDER ASSY.
J-2
9 430 612 836 
236002663A 
NOZZLE AND HOLDER ASSY.
J-2
105101-7704  

105101-7705 
9 430 612 837 
236002663B 
NOZZLE AND HOLDER ASSY.
J-2
9 430 611 627 
30-3601 
236002663C 
NOZZLE AND HOLDER ASSY.
J-2
Back to top