146982-1000 ZEXEL 9 461 624 746 BOSCH NAMEPLATE 9461624746 1469821000


 

Information nameplate

BOSCH 9 461 624 746 9461624746
ZEXEL 146982-1000 1469821000
146982-1000 NAMEPLATE
Rating:
8
Buy NAMEPLATE 146982-1000 zexel genuine, new aftermarket engine parts with delivery

Include in #2:

104780-9190 as NUMBER PLATE

Include in ###:

Number on scheme 906
NAMEPLATE
1047809190 as NAMEPLATE

Cross reference number

Zexel num
Bosch num
Firm num
Name
146982-1000 
9 461 624 746 
   
NAMEPLATE
C 11FV NUMBER PLATE parts(VE) Others




Information:


Before any service work is done on the fuel system, the outer surface of the fuel injection pump housing must be clean.
1. Cut governor safety wire (1).2. Disconnect line (3) from the fuel ratio control.3. Remove the two bolts and fuel ratio control (2).Install Fuel Ratio Control
1. Put fuel ratio control in position. Make an alignment of opening (slot) (2) with the plunger in the fuel ratio control.2. Use 9S3263 Thread Lock and install the two bolts that hold fuel ratio control (1) to the governor plate. 3. Connect line (3) to the fuel ratio control.4. Install a new lockwire and seal. See FUEL RACK SETTING in TESTING AND ADJUSTING.
The lockwire and seal must be installed in order to validate the warranty.
Disassemble Fuel Ratio Control
start by:a) remove fuel ratio control 1. Remove two bolts (1) and cover (2). 2. Remove valve assembly (3).3. Remove seal (4) and the O-ring seal from the valve assembly.4. Remove retainer (5) and two springs (6). 5. Remove the three bolts from the cover. Remove cover (12) and gasket (11).6. Remove valve (13), diaphragm, (8), retainer (9) and spring (10).7. Remove pin (14) from valve (13).8. Remove cover (7) from the valve.Assemble Fuel Ratio Control
1. Put clean SAE 30 oil on the seal. Install seal (1) in cover (2) with the lip of the seal toward the inside of the cover. 2. Install valve (3) in cover (2).3. Install the pin that holds the cover on the valve. 4. Install the spring and the retainer in cover (6).5. Install diaphragm (5) on the valve assembly (4) and in the cover.6. Install cover (8). Install three bolts (7) that hold the cover in position. 7. Put clean SAE 30 oil on the seal and the ring seal. Install seals (11) on valve.8. Install two springs (12), retainer (13) and valve assembly (10).9. Install housing (9) and the bolts.
Correct adjustment must be made to fuel ratio control before installation. See ADJUSTMENT OF AIR FUEL RATIO CONTROL in TESTING AND ADJUSTING.
end by:a) install fuel ratio control

Have questions with 146982-1000?





Group cross 146982-1000 ZEXEL

146982-1000  
9 461 624 746 
 
NAMEPLATE
Back to top