146979-3300 ZEXEL 9 461 628 271 BOSCH NAMEPLATE 9461628271 1469793300


 

Information nameplate

BOSCH 9 461 628 271 9461628271
ZEXEL 146979-3300 1469793300
146979-3300 NAMEPLATE
Rating:
23
Buy NAMEPLATE 146979-3300 zexel genuine, new aftermarket engine parts with delivery

Include in #2:

104746-5433 as NUMBER PLATE

Include in ###:

Number on scheme 906
NAMEPLATE
1047465433 as NAMEPLATE

Cross reference number

Zexel num
Bosch num
Firm num
Name
146979-3300 
9 461 628 271 
   
NAMEPLATE
C 11FV NUMBER PLATE parts(VE) Others




Information:

2. Remove the nuts (1), washers, and bearing caps from the cylinder block.3. Remove the crankshaft from block. Weight of crankshaft is 240 lb. (108 kg).4. Remove the bearings from main bearing caps. 5. Remove the upper halves (2) of bearings from the cylinder block.Install Crankshaft
1. Clean the surfaces for bearings in cylinder block. Install the upper halves of bearings in the block. Put clean oil on the bearings. 2. Fasten a hoist and put the crankshaft in position on block with "V" mark on crankshaft gear in alignment with "V" mark on cluster gear.3. Clean the bearings caps, and install the lower halves of bearings in caps. 4. Use wire (A) to check bearing clearances. Install the bearing caps, and tighten both nuts to 70 5 lb. ft. (9.7 0.7 mkg). Put a mark across the nuts and studs, and turn nuts an additional 90° from mark. Remove caps and check thickness of wire (A) to find bearing clearance. Bearing clearance must be .0030 to .0059 in. (0.07 to 0.14 mm) for new parts. Maximum permissible clearance for used parts is .010 in. (0.254 mm).5. Put clean engine oil on threads of studs, face of washers, and lower halves of bearings. Put the bearing caps in their respective positions with number on cap on same side and the same as number on cylinder block. Install washers and nuts. Tighten nuts to 70 5 lb.ft. (9.7 0.7 mkg). Put a mark across the nuts and studs, and turn nuts an additional 90° from mark as shown. 6. Use indicator group (B) to check the crankshaft end play as controlled by bearing (1) on No. 4 main bearing cap (2). End play with new parts should be .011 to .018 in. (0.28 to 0.46 mm). Maximum permissible end play with used parts is .035 in. (0.89 mm).end by: a) install timing gear housingb) install pistonsc) install front cover

Have questions with 146979-3300?





Group cross 146979-3300 ZEXEL

146979-3300  
9 461 628 271 
 
NAMEPLATE
Back to top