107692-3005 ZEXEL F 01G 09U 0DY BOSCH INJECTION-PUMP ASSEMBLY f01g09u0dy 1076923005 220008845a


 

Information injection-pump assembly

BOSCH F 01G 09U 0DY f01g09u0dy
ZEXEL 107692-3005 1076923005
HINO 220008845A 220008845a
107692-3005 INJECTION-PUMP ASSEMBLY
Rating:
26
Buy INJECTION-PUMP ASSEMBLY 107692-3005 zexel genuine, new aftermarket engine parts with delivery

Service parts 107692-3005 INJECTION-PUMP ASSEMBLY:

1. _
2. FUEL INJECTION PUMP 107069-1241
3. GOVERNOR 105923-1345
4. SUPPLY PUMP 105237-6370
5. AUTOM. ADVANCE MECHANIS
6. COUPLING PLATE 105662-1530
7. COUPLING PLATE 156638-8920
9. _
10. NOZZLE AND HOLDER ASSY 105101-7902
11. Nozzle and Holder 23600-2791A
12. Open Pre:MPa(Kqf/cm2) 14.7{150}/21.6{220}
13. NOZZLE-HOLDER 105030-4681
14. NOZZLE
15. NOZZLE SET 105019-0561

Include in #1:

107692-3005 as INJECTION-PUMP ASSEMBLY

Cross reference number

Zexel num
Bosch num
Firm num
Name
107692-3005 
107692-3006 
F 01G 09U 0DY 
220008845A  HINO
INJECTION-PUMP ASSEMBLY
M10U-D * K




Information:

Maintenance Recommendations
Caterpillar Inc. truck engines are certified by the United States Environmental Protection Agency (EPA) to comply with smoke and gaseous emission standards prescribed by Federal laws at the time of manufacture.Efficiency of emission control and engine performance depends on adherence to proper operation and maintenance recommendations AND use of recommended fuels and lubricating oils. It is recommended that major adjustments and repair be made by your authorized Caterpillar dealer.Various chemical fuel additives claiming to reduce visible smoke are available commercially. Although additives have been used by individuals to solve some isolated smoke problems in the field, they are not recommended for general use. Federal smoke regulations require that engines be certified without smoke depressants.The corrective steps taken immediately on discovery of worn parts, which may affect emission levels, will help assure proper operation of emission control systems. The use of genuine Caterpillar parts is recommended. Suppliers of non-Caterpillar parts must assure the owner that the use of such parts will not adversely affect emission levels.Regular maintenance intervals, along with special emphasis on the following items, are necessary to keep exhaust emissions within acceptable limits for the useful life of the engine. Refer to the Maintenance Section of this manual. If the engine is operating under severe conditions, adjust the maintenance schedule accordingly. See your authorized Caterpillar dealer to help analyze your specific application, operating environment and maintenance schedule adjustments.The following is an explanation of maintenance for emission-related components. See the Maintenance Schedule for the specific interval for the following items. ELECTRONIC UNIT INJECTORS - Fuel nozzles are subject to tip wear as a result of fuel contamination. This damage can cause an increase in fuel consumption, the engine to emit black smoke, misfire or run rough. Inspect and replace if necessary. Fuel injectors can be tested by an authorized Caterpillar truck engine dealer. TURBOCHARGER - Check for any unusual sound or vibration in the turbocharger. Inspect inlet and exhaust piping and connections. Check bearing condition and perform maintenance as described in the Maintenance Schedule. AIR/FUEL RATIO CONTROL - This component is a device to control the smoke emission of an engine during its operation when low inlet manifold pressure exists.Slow engine response and low power may indicate a need for adjustment or repair. Your Caterpillar dealer is equipped with the necessary tools, personnel and procedures to perform this service.Owner is encouraged to keep adequate maintenance records, but the absence of such, in and of itself, will not invalidate the warranty.The vehicle owner may perform routine maintenance, repairs and other non warranty work or have it done at any repair facility. Such non warranty work need not be performed at a designated warranty station in order for the warranty to remain in force.Customer Assistance-Emission Control Systems Warranty
Caterpillar Inc. aims to ensure that the Emission Control Systems warranty is properly administered. In the event that you do not receive the warranty service to which you believe you are entitled under the Emission Control Systems Warranty, call or write:Caterpillar Inc.
Manager,

Have questions with 107692-3005?





Group cross 107692-3005 ZEXEL

Hino 

 
220008840A 
INJECTION-PUMP ASSEMBLY
M10U-D
F 019 Z20 350 
220008841A 
INJECTION-PUMP ASSEMBLY
M10U-D
F 01G 09U 0J2 
220008842A 
INJECTION-PUMP ASSEMBLY
 
220008843A 
INJECTION-PUMP ASSEMBLY
M10U-D
F 01G 09U 0DX 
220008844A 
INJECTION-PUMP ASSEMBLY
M10U-D
107692-3005  

107692-3006 
F 01G 09U 0DY 
220008845A 
INJECTION-PUMP ASSEMBLY
M10U-D
 
220008846A 
INJECTION-PUMP ASSEMBLY
M10U-D
F 01G 09U 0DZ 
 
INJECTION-PUMP ASSEMBLY

Hino 

F 01G 09U 0E0 
220008847A 
INJECTION-PUMP ASSEMBLY
M10U-D
F 01G 09U 0E1 
220008848A 
INJECTION-PUMP ASSEMBLY
M10U-D
Back to top