107692-1661 ZEXEL 9 400 619 030 BOSCH INJECTION-PUMP ASSEMBLY 9400619030 1076921661 8976021520


 

Information injection-pump assembly

BOSCH 9 400 619 030 9400619030
ZEXEL 107692-1661 1076921661
ISUZU 8976021520 8976021520
107692-1661 INJECTION-PUMP ASSEMBLY
Rating:
26
Buy INJECTION-PUMP ASSEMBLY 107692-1661 zexel genuine, new aftermarket engine parts with delivery

Cross reference number

Zexel num
Bosch num
Firm num
Name
107692-1661 
9 400 619 030 
8976021520  ISUZU
INJECTION-PUMP ASSEMBLY
6HH1 K 14CG INJECTION PUMP ASSY TICS MD-TI6 TICS




Information:

Startability will be improved at temperatures below +32°F (0°C) by the use of a starting aid and/or use of a cylinder block coolant heater or other means to heat the crankcase oil.Start the engine using the following procedure:1. Place the transmission in NEUTRAL and disengage the flywheel clutch (if equipped) to remove the transmission drag and prevent movement of the truck. Depressing the clutch in cold weather can mean the difference between starting and not starting. Depressing the clutch in warm weather produces faster starts and reduces battery drain.2. Turn the ignition switch to the ON position and push the crank button or turn the ignition switch to the START position. Crank the engine. (At temperatures below +32°F (0°C), it may be necessary to spray starting fluid into the air cleaner inlet.) DO NOT PUSH DOWN OR HOLD THE THROTTLE DOWN while cranking the engine. The PEEC system will automatically provide the correct amount of fuel to start the engine. The PEEC equipped engine may need to crank slightly longer than a mechanically governed engine, because some oil pressure is required for the electronic actuator to move the rack. The "CHECK ENGINE" light should be ON while the engine is cranking, but should go OFF after engine oil pressure is achieved.If the engine fails to start in 30 seconds, release the starter switch and wait two minutes to allow the starter motor to cool before using it again.
When using starting fluid, follow the manufacturer's instructions carefully, use it sparingly and spray it only while cranking the engine. Also, do not store starting fluid containers in the cab. Failure to do so, could result in an explosion and/or fire and possible personal injury.
Excessive ether can cause piston and ring damage. Use ether for cold starting purposes only.
3. As soon as the engine starts, allow the engine to idle for two or three minutes, or until the water temperature gauge indicator has begun to rise.4. Do not apply load to the engine or increase engine speed until the oil pressure gauge indicates normal. Oil pressure should rise within 15 seconds after the engine starts.5. Operate the engine at low load until all systems reach operating temperature. Check all gauges during the warm-up period.Starting With Jumper Cables
Batteries give off flammable fumes that can explode. Improper jumper cable connections can cause an explosion resulting in personal injury.Prevent sparks near the batteries. Sparks could cause vapors to explode. Do not allow jumper cable ends to contact each other or the engine.Do not smoke when observing the battery electrolyte levels.Always wear protective glasses when working with batteries.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.
Engines installed without engine-to-frame ground straps can be damaged by electrical discharge.To prevent electrical discharge damage, check to make sure the engine's electrical system has an engine-to-frame ground strap. For engines which have the alternator connected to an engine component, the ground strap must connect that component to the frame.Some engines have starter-to-frame

Have questions with 107692-1661?





Group cross 107692-1661 ZEXEL

Isuzu 

9 400 612 321 
8976006650 
INJECTION-PUMP ASSEMBLY
6HK1-TC
 
 
INJECTION-PUMP ASSEMBLY

Isuzu 

9 400 612 438 
8976006651 
INJECTION-PUMP ASSEMBLY
6HK1-TC
9 400 612 473 
8976006652 
INJECTION-PUMP ASSEMBLY
6HK1-TC
9 400 612 721 
8976006653 
INJECTION-PUMP ASSEMBLY
6HK1-TC
9 400 619 027 
8976006654 
INJECTION-PUMP ASSEMBLY
6HK1-TC
9 400 619 886 
8976017170 
INJECTION-PUMP ASSEMBLY
6HK1-TC
9 400 612 680 
8976017171 
INJECTION-PUMP ASSEMBLY
6HK1-TC
9 400 612 916 
8976017172 
INJECTION-PUMP ASSEMBLY
6HK1-TC
9 400 619 713 
8976017173 
INJECTION-PUMP ASSEMBLY
6HK1-TC
9 400 612 474 
8976021661 
INJECTION-PUMP ASSEMBLY
6HK1-TC
 
8976021662 
INJECTION-PUMP ASSEMBLY
6HK1-TC
9 400 612 917 
8976021663 
INJECTION-PUMP ASSEMBLY
6HK1-TC
F 019 Z10 760 
8976021664 
INJECTION-PUMP ASSEMBLY
6HK1-TC
9 400 612 642 
 
INJECTION-PUMP ASSEMBLY

Isuzu 

9 400 613 407 
8976021310 
INJECTION-PUMP ASSEMBLY
6HH1
F 019 Z10 761 
 
INJECTION-PUMP ASSEMBLY

Isuzu 

9 400 619 028 
8976021500 
INJECTION-PUMP ASSEMBLY
6HH1
F 019 Z10 762 
 
INJECTION-PUMP ASSEMBLY

Isuzu 

9 400 619 029 
8976021510 
INJECTION-PUMP ASSEMBLY
6HH1
F 019 Z10 763 
 
INJECTION-PUMP ASSEMBLY

Isuzu 

107692-1661  
9 400 619 030 
8976021520 
INJECTION-PUMP ASSEMBLY
6HH1
9 400 612 722 
 
INJECTION-PUMP ASSEMBLY

Isuzu 

9 400 613 408 
8976021530 
INJECTION-PUMP ASSEMBLY
6HH1
F 019 Z10 764 
 
INJECTION-PUMP ASSEMBLY

Isuzu 

9 400 619 031 
8976021540 
INJECTION-PUMP ASSEMBLY
6HH1
9 400 612 723 
 
INJECTION-PUMP ASSEMBLY

Isuzu 

9 400 619 032 
8976021550 
INJECTION-PUMP ASSEMBLY
6HH1
Back to top