106961-1476 ZEXEL 9 400 618 598 BOSCH INJECTION-PUMP ASSEMBLY 9400618598 1069611476 1156018797

Information injection-pump assembly

BOSCH 9 400 618 598 9400618598

ZEXEL 106961-1476 1069611476

ISUZU 1156018797 1156018797

Price: query

Buy now
Add to cart Go to cart

Rating:

Buy INJECTION-PUMP ASSEMBLY 106961-1476 zexel genuine, new aftermarket engine parts with delivery

Service parts 106961-1476 INJECTION-PUMP ASSEMBLY:

1. _

2. FUEL INJECTION PUMP 106096-9193

3. GOVERNOR 105488-0310

4. SUPPLY PUMP

105237-4421

5. AUTOM. ADVANCE MECHANIS 105687-0681

6. COUPLING PLATE

7. COUPLING PLATE

8. _

9. _

10. NOZZLE AND HOLDER ASSY 105100-7003

11. Nozzle and Holder 1-15300-138-2

12. Open Pre:MPa(Kqf/cm2) 15.7(160)/22.1(225)

13. NOZZLE-HOLDER 105031-4831

14. NOZZLE

105015-6250

15. NOZZLE SET

Include in #1:

106961-1476 as INJECTION-PUMP ASSEMBLY

Cross reference number

Zexel num

Bosch num

Firm num

Name

106961-1476

9 400 618 598

1156018797 ISUZU

INJECTION-PUMP ASSEMBLY
10PC1 K

Information:

Illustration 1 g00858201
(1) PCI Slot (2) Shared PCI/ISA Slot (3) DIMM Memory (4) Slot Cover (5) I/O Card Slot (6) CPU Slot (7) ScrewIn order to install the CPU board, perform the following procedure:
Remove the board from the anti-static packaging. Place the board on a ground, static free surface.
Illustration 2 g00858199
(8) Jumper JP2
The instructions for the board explain the locations of any jumpers or switches that need to be placed.Note: If you are replacing the CPU board, make a careful note of the cables that are attached to the existing CPU board. This will help you reconnect the cables to the new board.Note: The CPU board contains a video jumper setting that is specific to each version of the monitor. If jumper JP2 (8) is set incorrectly, the monitor video circuitry may be damaged.
Hold the board by the edges. Press the board firmly into the connector on the processor board.Note: Do not disturb the air flow director. The air flow director is required in order to keep the CPU cool. The air flow director should be routed behind the two add-in card slots. The air flow director should extend alongside the CPU heatsink.
Illustration 3 g00860148
(9) Board Retainer (10) Screw
Align the notch in the board retainer with the threaded hole. Install the screw. Hold the notch tightly against the screw before you tighten the screw.Note: Install the retainer tightly against the screw. If the retainer is not correctly installed, problems may occur when you insert an adjacent board.