Information injection-pump assembly
ZEXEL
106891-1245
1068911245
ISUZU
1156025035
1156025035
Rating:
Service parts 106891-1245 INJECTION-PUMP ASSEMBLY:
1.
_
6.
COUPLING PLATE
7.
COUPLING PLATE
8.
_
9.
_
11.
Nozzle and Holder
1-15300-204-1
12.
Open Pre:MPa(Kqf/cm2)
15.7{160}/22.1{225}
15.
NOZZLE SET
Include in #1:
106891-1245
as INJECTION-PUMP ASSEMBLY
Cross reference number
Zexel num
Bosch num
Firm num
Name
Information:
1. Once all connections have been checked, energize the system.A) The RED indicator light should come on. This indicates that the control is 'OFF'.*... If the LO indicator light is 'ON', it indicates an open connection on the BLUE output wire going to the center solenoid.... If the MED indicator light is 'ON', it indicates an open connection on the YELLOW output wire going to the front and/or rear solenoids*If the RED light starts to flash: This indicates that there is an open connection on the output.If an open connection occurs, insure that there is a good connection at the solenoid, and at the output of the control module. If there is still a problem remove the harness connections on the 002299 terminal leadout. Measure the resistance of the solenoid at the 002299 terminal leadout on the Jake Brake housing (+ probe on the 002299 terminal, - probe to ground). The ohmmeter should read between 7 and 14 ohms. If it does not, replace the solenoid. If the problem still occurs, replace the suspected output wire, and insure a good connection