Information injection-pump assembly
BOSCH
9 400 612 132
9400612132
ZEXEL
106689-4031
1066894031
KOMATSU
6215711320
6215711320
Rating:
Service parts 106689-4031 INJECTION-PUMP ASSEMBLY:
1.
_
3.
GOVERNOR
7.
COUPLING PLATE
8.
_
9.
_
11.
Nozzle and Holder
6215-11-3201
12.
Open Pre:MPa(Kqf/cm2)
27.5{280}
15.
NOZZLE SET
Include in #1:
106689-4031
as INJECTION-PUMP ASSEMBLY
Cross reference number
Zexel num
Bosch num
Firm num
Name
106689-4031
9 400 612 132
6215711320 KOMATSU
INJECTION-PUMP ASSEMBLY
SA12V140 K 14CA INJECTION PUMP ASSY PE6P,6PD PE
SA12V140 K 14CA INJECTION PUMP ASSY PE6P,6PD PE
Information:
1. Disconnect fuel line (1).2. Remove two bolts (2). Remove the fuel transfer pump. The following steps are for the installation of the fuel transfer pump.3. Be sure the O-ring seal is in place on the fuel transfer pump. Lightly lubricate O-ring seal with engine oil before assembly. Install the fuel transfer pump. Install two bolts (2).4. Connect fuel line (1). Connect fuel supply line to fuel transfer pump.Disassemble & Assemble Fuel Transfer Pump
Start By:a. remove fuel transfer pump 1. Remove two bolts (1) and remove cover (2). 2. Remove gear (3).
Before removing input shaft and gear (5) from pump housing, be sure no burrs exist on the input shaft. If the shaft has burrs it could scratch the pump housing and damage it.
3. Install Tooling (A) and remove drive gear (4), then remove gear and shaft (5) from pump housing.4. Inspect and replace if necessary seal group (6). Inspect by-pass valve (7). The following steps are for the assembly of the fuel transfer pump.4. Install shaft and gear (5) in pump housing, then press gear (4) onto shaft until gear (4) is flush with the end of the shaft.5. Install gear (3).6. Be sure the cover is in place, position cover (2) and install two bolts (1).End By:a. install fuel transfer pump
Start By:a. remove fuel transfer pump 1. Remove two bolts (1) and remove cover (2). 2. Remove gear (3).
Before removing input shaft and gear (5) from pump housing, be sure no burrs exist on the input shaft. If the shaft has burrs it could scratch the pump housing and damage it.
3. Install Tooling (A) and remove drive gear (4), then remove gear and shaft (5) from pump housing.4. Inspect and replace if necessary seal group (6). Inspect by-pass valve (7). The following steps are for the assembly of the fuel transfer pump.4. Install shaft and gear (5) in pump housing, then press gear (4) onto shaft until gear (4) is flush with the end of the shaft.5. Install gear (3).6. Be sure the cover is in place, position cover (2) and install two bolts (1).End By:a. install fuel transfer pump
Have questions with 106689-4031?
Group cross 106689-4031 ZEXEL
Daihatsu
Komatsu
Komatsu
Mitsubishi-Heav
Komatsu
106689-4031
9 400 612 132
6215711320
INJECTION-PUMP ASSEMBLY
SA12V140
SA12V140