106684-4511 ZEXEL 9 400 617 690 BOSCH INJECTION-PUMP ASSEMBLY 9400617690 1066844511 3626511310


 

Information injection-pump assembly

BOSCH 9 400 617 690 9400617690
ZEXEL 106684-4511 1066844511
MITSUBISHI-HEAV 3626511310 3626511310
106684-4511 INJECTION-PUMP ASSEMBLY
Rating:
86
Buy INJECTION-PUMP ASSEMBLY 106684-4511 zexel genuine, new aftermarket engine parts with delivery

Service parts 106684-4511 INJECTION-PUMP ASSEMBLY:

1. _
2. FUEL INJECTION PUMP 106068-4050
3. GOVERNOR
4. SUPPLY PUMP 105237-1690
5. AUTOM. ADVANCE MECHANIS
6. COUPLING PLATE 105664-2640
7. COUPLING PLATE 156643-6320
8. _
9. _
10. NOZZLE AND HOLDER ASSY 105110-6130
11. Nozzle and Holder
12. Open Pre:MPa(Kqf/cm2) 29.4(300)
13. NOZZLE-HOLDER 105040-5080
14. NOZZLE 105025-3900
15. NOZZLE SET

Include in #1:

106684-4511 as INJECTION-PUMP ASSEMBLY

Cross reference number

Zexel num
Bosch num
Firm num
Name
106684-4511 
9 400 617 690 
3626511310  MITSUBISHI-HEAV
INJECTION-PUMP ASSEMBLY
S6B K




Information:

Air Cleaner
Check Service Indicator
Typical service indicator, mounted on the air cleaner housing. Your engine may be equipped with a different indicator.Some vessels are equipped with an inlet air pressure differential gauge. The gauge reads the difference between inlet air pressure before and after the air cleaner. As the air cleaner filter element becomes dirty, the pressure differential rises. If your vessel is equipped with a gauge or some other type of air cleaner service indicator, follow the vessel or air cleaner OEM recommendations for servicing the air cleaner.A service indicator may be mounted on the air cleaner or in a remote location. A colored piston showing in the window indicates the need for servicing the air cleaner.
Typical service indicator.Observe the air cleaner service indicator. Clean or replace the air cleaner filter element when the yellow diaphragm enters the red zone or the red piston locks in the visible position. If the air cleaner indicator shows red at any time, clean the filter element or install a new element.Test Service Indicator
Air cleaner service indicators are inexpensive but important instruments.* Check for ease of resetting. The indicator should reset in less than three pushes.* Check the movement of the yellow core when the engine is accelerated to rated speed. The yellow core should latch approximately at the greatest vacuum that is attained.If the indicator does not reset easily, or if the yellow core does not latch at the greatest vacuum, the indicator should be replaced. If the new indicator will not reset, the indicator sensor hole may be plugged.Severely dusty environments may require frequent indicator replacements. Replace the indicator yearly, regardless of operating conditions. Replace the indicator at Overhaul, and whenever major engine components are replaced. When you install a new indicator, excessive force may crack the top of the indicator. Tighten the indicator to a torque of 2 N m (18 lb in).Service Air Cleaner
Never run the engine without an air cleaner installed. Never run the engine with a damaged air cleaner. Do not use filter elements with damaged pleats, gaskets or seals. Dirt entering the engine causes premature wear and damage to engine components. Air cleaners prevent airborne debris from entering the engine through the air inlet.
Never service the air cleaner with the engine running since this will allow dirt to enter the engine.
If your air cleaner element becomes plugged, the air can split the element filter material. Unfiltered air will drastically accelerate internal engine wear. Your Caterpillar dealer has air filter elements to service this unit. Contact your Caterpillar dealer for the correct filter element.If the air cleaner indicator shows red at any time, clean the filter element or install a new element. Clean or replace air cleaner filter elements at least Every 250 Hours. Severely dusty environments may require more frequent air cleaner service.Refer to the Air Cleaner topic in the Every 250 Hours section of this manual.Air Starter
Check Lubricator Oil Level
Never allow the lubricator bowl (if equipped) to become empty. The starting motor will be

Have questions with 106684-4511?





Group cross 106684-4511 ZEXEL

Mitsubishi-Heav 

9 400 617 689 
3266500310 
INJECTION-PUMP ASSEMBLY
S12A2
 
3626501310 
INJECTION-PUMP ASSEMBLY
S6B
106684-4511  
9 400 617 690 
3626511310 
INJECTION-PUMP ASSEMBLY
S6B
9 400 613 016 
35A6501090 
INJECTION-PUMP ASSEMBLY
S6A3
9 400 617 691 
35A6501250 
INJECTION-PUMP ASSEMBLY
S6B
9 400 617 692 
3266500210 
INJECTION-PUMP ASSEMBLY
S12A2
F 019 Z20 203 
3266500270 
INJECTION-PUMP ASSEMBLY
S12A2
F 01G 09U 1J7 
3266510270 
INJECTION-PUMP ASSEMBLY
S12A2
9 400 613 486 
3266500220 
INJECTION-PUMP ASSEMBLY
S12A2
F 019 Z20 204 
 
INJECTION-PUMP ASSEMBLY
S12A2

Mitsubishi-Heav 

F 019 Z20 204 
3266500280 
INJECTION-PUMP ASSEMBLY
S12A2
F 01G 09U 1J8 
3266510280 
INJECTION-PUMP ASSEMBLY
S12A2
Back to top