106684-4322 ZEXEL 9 400 613 070 BOSCH INJECTION-PUMP ASSEMBLY 9400613070 1066844322 35a6521320


 

Information injection-pump assembly

BOSCH 9 400 613 070 9400613070
ZEXEL 106684-4322 1066844322
MITSUBISHI-HEAV 35A6521320 35a6521320
106684-4322 INJECTION-PUMP ASSEMBLY
Rating:
23
Buy INJECTION-PUMP ASSEMBLY 106684-4322 zexel genuine, new aftermarket engine parts with delivery

Service parts 106684-4322 INJECTION-PUMP ASSEMBLY:

1. _
2. FUEL INJECTION PUMP 106068-2664
3. GOVERNOR
4. SUPPLY PUMP 105237-1690
5. AUTOM. ADVANCE MECHANIS
6. COUPLING PLATE 105664-0670
7. COUPLING PLATE 156638-8320
8. _
9. _
10. NOZZLE AND HOLDER ASSY 105101-6220
11. Nozzle and Holder 35A61-00010
12. Open Pre:MPa(Kqf/cm2) 21.6{220}
13. NOZZLE-HOLDER 105030-4320
14. NOZZLE 105015-8520
15. NOZZLE SET

Include in #1:

106684-4322 as INJECTION-PUMP ASSEMBLY

Cross reference number

Zexel num
Bosch num
Firm num
Name
106684-4322 
9 400 613 070 
35A6521320  MITSUBISHI-HEAV
INJECTION-PUMP ASSEMBLY
S6B3 K 14CA INJECTION PUMP ASSY PE6P,6PD PE




Information:

Your truck/engine may not have the same or all of the gauges as shown in the illustrations. The illustrations shown are of typical gauges.Gauges provide a "look" inside the engine. Be sure they are in good working order. You can determine what is the "normal" operating range by observing your gauges over a period of time.Noticeable changes in gauge readings are an indication of potential gauge or engine problems. This also applies to gauge readings that have changed significantly but are still within specifications. The cause of any sudden or significant change in the readings should be determined and corrected. Contact your Caterpillar dealer for assistance as needed.
If no oil pressure is indicated, stop the engine. Engine damage can result.
Oil Pressure - Typical oil pressure range is 30 and 45 psi (207 and 310 kPa) (running at rated engine speed, with SAE 15W-40 oil, at operating temperature). A lower pressure is normal at low idle. Water Temperature - Typical water temperature range is 189° to 208°F (87° to 98°C). Maximum allowable temperature is 216°F (102°C) with the cooling system pressurized. Somewhat higher temperatures may occur under certain conditions. Ammeter - Indicates the amount of charge or discharge in the battery charging circuit. Typical operation of the indicator should be slightly to the positive (right) side of "0" (zero).With the engine running, during normal operation, if the indicator is constantly to the negative (left) side of "0" (zero) or shows excessive charge, have the charging system checked for malfunction.
Do not exceed 2300 rpm in any situation.
Tachometer - Indicates engine rpm (speed). The engine can be operated at high idle without damage, but should not be allowed to overspeed. Overspeeding when downshifting, going downhill, etc., can result in serious damage to your engine. Fuel Level - Indicates fuel level in the fuel tank. Electrically operated, it registers only when the key switch is ON.
A drop in fuel pressure usually indicates a dirty or plugged fuel filter.
Fuel Pressure - Indicates fuel pressure to the unit injectors. The indicator (if equipped) should register in the NORMAL (green) range. Typical fuel pressure at low idle is 60 psi (410 kPa) and at TEL (Top Engine Limit), 80 psi (550 kPa).

Have questions with 106684-4322?





Group cross 106684-4322 ZEXEL

 
 
INJECTION-PUMP ASSEMBLY
9 400 611 471 
 
INJECTION-PUMP ASSEMBLY

Komatsu 

9 400 613 069 
6215711940 
INJECTION-PUMP ASSEMBLY
SA12V140
 
 
INJECTION-PUMP ASSEMBLY
 
 
INJECTION-PUMP ASSEMBLY

Komatsu 

9 400 613 273 
6215711960 
INJECTION-PUMP ASSEMBLY
SA12V140

Mitsubishi-Heav 

9 400 611 906 
35A6501320 
INJECTION-PUMP ASSEMBLY
S6B3
9 400 612 468 
35A6511320 
INJECTION-PUMP ASSEMBLY
S6B3
106684-4322  
9 400 613 070 
35A6521320 
INJECTION-PUMP ASSEMBLY
S6B3

Komatsu 

9 400 612 983 
6215711980 
INJECTION-PUMP ASSEMBLY
SA12V140
9 400 613 322 
6166711760 
INJECTION-PUMP ASSEMBLY
SA12V170

Mitsubishi-Heav 

9 400 611 542 
3266501040 
INJECTION-PUMP ASSEMBLY
S12A2
9 400 612 548 
3266521040 
INJECTION-PUMP ASSEMBLY
S12A2
9 400 612 810 
3266531040 
INJECTION-PUMP ASSEMBLY
S12A2
9 400 611 543 
3266502040 
INJECTION-PUMP ASSEMBLY
S12A2
9 400 612 549 
3266512040 
INJECTION-PUMP ASSEMBLY
S12A2
9 400 612 811 
3266522040 
INJECTION-PUMP ASSEMBLY
S12A2
9 400 611 628 
 
INJECTION-PUMP ASSEMBLY
9 400 612 281 
 
INJECTION-PUMP ASSEMBLY
SA12V140
 
 
INJECTION-PUMP ASSEMBLY
 
 
INJECTION-PUMP ASSEMBLY

Komatsu 

9 400 613 444 
6215712140 
INJECTION-PUMP ASSEMBLY
SA12V140
F 019 Z20 195 
6215712141 
INJECTION-PUMP ASSEMBLY
SA12V140
 
 
INJECTION-PUMP ASSEMBLY
SA12V140
 
 
INJECTION-PUMP ASSEMBLY
 
 
INJECTION-PUMP ASSEMBLY
 
 
INJECTION-PUMP ASSEMBLY

Komatsu 

9 400 617 678 
6215711871 
INJECTION-PUMP ASSEMBLY
SA12V140
F 019 Z20 196 
6215711872 
INJECTION-PUMP ASSEMBLY
SA12V140
9 400 611 629 
 
INJECTION-PUMP ASSEMBLY
 
 
INJECTION-PUMP ASSEMBLY
SA12V140
9 400 612 435 
 
INJECTION-PUMP ASSEMBLY
 
 
INJECTION-PUMP ASSEMBLY
 
 
INJECTION-PUMP ASSEMBLY

Komatsu 

9 400 617 679 
6215711990 
INJECTION-PUMP ASSEMBLY
SA12V140
F 019 Z20 197 
6215711991 
INJECTION-PUMP ASSEMBLY
SA12V140
Back to top