106671-8911 ZEXEL 9 400 610 897 BOSCH INJECTION-PUMP ASSEMBLY 9400610897 1066718911 220009340b


 

Information injection-pump assembly

BOSCH 9 400 610 897 9400610897
ZEXEL 106671-8911 1066718911
HINO 220009340B 220009340b
106671-8911 INJECTION-PUMP ASSEMBLY
Rating:
66
Buy INJECTION-PUMP ASSEMBLY 106671-8911 zexel genuine, new aftermarket engine parts with delivery

Service parts 106671-8911 INJECTION-PUMP ASSEMBLY:

1. _
2. FUEL INJECTION PUMP 106067-0291
3. GOVERNOR 105488-2301
4. SUPPLY PUMP 105237-5040
5. AUTOM. ADVANCE MECHANIS 105681-5320
6. COUPLING PLATE 105663-0620
7. COUPLING PLATE
8. _
9. _
10. NOZZLE AND HOLDER ASSY 105101-7366
11. Nozzle and Holder 23600-2412E
12. Open Pre:MPa(Kqf/cm2) 16.7{170}/23.5{240}
13. NOZZLE-HOLDER 105030-3482
14. NOZZLE
15. NOZZLE SET 105019-0161

Include in #1:

106671-8911 as INJECTION-PUMP ASSEMBLY

Cross reference number

Zexel num
Bosch num
Firm num
Name
106671-8911 
106671-8912 
9 400 610 897 
220009340B  HINO
INJECTION-PUMP ASSEMBLY
K13C-TF * K 14CA PE6P,6PD PE




Information:

Introduction
This Special Instruction contains the procedure for contamination test in the Diesel Exhaust Fluid (DEF) system.There have been instances of issues with DEF pumps. After analysis, the cause of the issues has been found as contamination with hydrocarbons.Note: Diesel fuel is an example of a hydrocarbon.The DEF filter is equipped with a compensator located in the center of the filter assembly. If the compensator comes into contact with hydrocarbons, the compensator will swell and is designed to block the filter assembly and protect the DEF pump.Do not perform any procedure in this Special Instruction until you have read the information and you understand the information.Safety Section
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Ensure that the engine is stopped before any servicing or repair is performed. The Diesel Exhaust Fluid (DEF) system must have completed a proper shutdown. Service on the DEF pump prior to completion of a proper shutdown can result in DEF spray and spillage.
Do not turn off the battery disconnect switch until the indicator lamp has turned off. If the switch is turned off when the indicator lamp is illuminated, the Diesel Exhaust Fluid (DEF) system may not shut down properly. If the DEF system does not shut down properly, DEF could freeze and damage the pump and lines.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Cat Dealer Service Tool Catalog" or refer to Special Publication, PECJ0003, "Cat Shop Supplies and Tools Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Note: Clean water should be used to wash spilled DEF off machine components and surfaces.Note: Wear gloves when handling the DEF filter.Contamination Test Procedure
The following procedure is designed to diagnose if the DEF pump has been contaminated with hydrocarbons.
Illustration 1 g06278274
(1) Protective cover
Remove the protective cover (1).
Illustration 2 g06278289
(2) DEF filter cap
Use a suitable tool to remove the DEF filter cap (2).
Illustration 3 g06278325
(3) Compensator
With the filter installed in the DEF pump, carefully remove the compensator (3).
Illustration 4 g06340998
(D1) 38 mm (1.5 inch)
(D2) 97 mm (3.8 inch)
Check the measurements of the compensator (3). Check if the measurements are greater than specified in Illustration 4. This condition indicates that the DEF pump is contaminated with hydrocarbons. The compensator will swell when exposed to hydrocarbons and this will block the flow through the filter. This condition will cause the following codes:
4334-18 DEF Pressure is Low
5435-1 DEF Pump Failed to Prime
If the measurements indicate contamination, replace the DEF pump filter. Refer to Operation and Maintenance Manual, Diesel Exhaust Fluid Filter -

Have questions with 106671-8911?





Group cross 106671-8911 ZEXEL

Hino 

9 400 617 029 
220204750A 
INJECTION-PUMP ASSEMBLY
K13C-T
 
220009340A 
INJECTION-PUMP ASSEMBLY
K13C-TF
106671-8911  

106671-8912 
9 400 610 897 
220009340B 
INJECTION-PUMP ASSEMBLY
K13C-TF
9 400 612 465 
220009341A 
INJECTION-PUMP ASSEMBLY
K13C-TF
9 400 612 465 
S220009341 
INJECTION-PUMP ASSEMBLY
K13C-TF
9 400 617 030 
220801760A 
INJECTION-PUMP ASSEMBLY
9 400 617 030 
220801760B 
INJECTION-PUMP ASSEMBLY
F 019 Z10 126 
220204830A 
INJECTION-PUMP ASSEMBLY
P09B-TI
F 01G 09U 07Y 
220204831A 
INJECTION-PUMP ASSEMBLY
P09B-TI
9 400 610 898 
220204832A 
INJECTION-PUMP ASSEMBLY
P09B-TI
9 400 619 863 
220204810A 
INJECTION-PUMP ASSEMBLY
K13C-T
9 400 613 509 
220204811A 
INJECTION-PUMP ASSEMBLY
K13C-T
 
220204790A 
INJECTION-PUMP ASSEMBLY
K13D-T
9 400 617 031 
220204800A 
INJECTION-PUMP ASSEMBLY
K13C-T
 
220204920A 
INJECTION-PUMP ASSEMBLY
K13D-T
9 400 610 899 
 
INJECTION-PUMP ASSEMBLY

Hino 

9 400 612 120 
220204920B 
INJECTION-PUMP ASSEMBLY
K13D-T
 
220009430A 
INJECTION-PUMP ASSEMBLY
K13D
 
220009580A 
INJECTION-PUMP ASSEMBLY
K13D
9 400 610 379 
 
INJECTION-PUMP ASSEMBLY

Hino 

9 400 617 032 
220009581A 
INJECTION-PUMP ASSEMBLY
K13D
 
220204930A 
INJECTION-PUMP ASSEMBLY
K13C-T
9 400 612 665 
220204931A 
INJECTION-PUMP ASSEMBLY
K13C-TJ
Back to top