Information injection-pump assembly
BOSCH
9 400 616 833
9400616833
ZEXEL
106671-4883
1066714883
NIIGATA-URAWA
W1N47101D
w1n47101d
Rating:
Service parts 106671-4883 INJECTION-PUMP ASSEMBLY:
1.
_
7.
COUPLING PLATE
8.
_
9.
_
10.
NOZZLE AND HOLDER ASSY
11.
Nozzle and Holder
12.
Open Pre:MPa(Kqf/cm2)
13.
NOZZLE-HOLDER
14.
NOZZLE
15.
NOZZLE SET
Include in #1:
106671-4883
as INJECTION-PUMP ASSEMBLY
Cross reference number
Zexel num
Bosch num
Firm num
Name
9 400 616 833
W1N47101D NIIGATA-URAWA
INJECTION-PUMP ASSEMBLY
DMF13HS K 14CA INJECTION PUMP ASSY PE6P,6PD PE
DMF13HS K 14CA INJECTION PUMP ASSY PE6P,6PD PE
Information:
1. Disconnect fuel line (1).2. Remove two bolts (2) and remove the fuel transfer pump. The following steps are for the installation of the fuel transfer pump.3. Be sure the o-ring seal is in place on the fuel transfer pump. Install the fuel transfer pump and install bolts (2).4. Connect fuel line (1). Connect fuel supply line.Disassemble And Assemble Fuel Transfer Pump
Start By:a. remove fuel transfer pump 1. Remove two bolts (1) and remove cover (2). 2. Remove gear (3).
Before removing input shaft and gear (5) from pump housing, be sure no burrs exist on the input shaft. If the shaft has burrs it could scratch the pump housing and damage it.
3. Install tooling (A) and remove drive gear (4), then remove gear and shaft (5) from pump housing.4. Inspect and replace if necessary seal group (6). Inspect by-pass valve (7). The following steps are for the assembly of the fuel transfer pump.4. Install shaft and gear (5) in pump housing, then press gear (4) onto shaft until gear (4) is flush with the end of the shaft.5. Install gear (3).6. Be sure the cover seal is in place, position cover (2) and install bolts (1).End By:a. install fuel transfer pump
Start By:a. remove fuel transfer pump 1. Remove two bolts (1) and remove cover (2). 2. Remove gear (3).
Before removing input shaft and gear (5) from pump housing, be sure no burrs exist on the input shaft. If the shaft has burrs it could scratch the pump housing and damage it.
3. Install tooling (A) and remove drive gear (4), then remove gear and shaft (5) from pump housing.4. Inspect and replace if necessary seal group (6). Inspect by-pass valve (7). The following steps are for the assembly of the fuel transfer pump.4. Install shaft and gear (5) in pump housing, then press gear (4) onto shaft until gear (4) is flush with the end of the shaft.5. Install gear (3).6. Be sure the cover seal is in place, position cover (2) and install bolts (1).End By:a. install fuel transfer pump