106651-0581 ZEXEL INJECTION-PUMP ASSEMBLY Cross 1066510581

Information injection-pump assembly

ZEXEL 106651-0581 1066510581

Price: query

Buy now
Add to cart Go to cart

Rating:

Buy INJECTION-PUMP ASSEMBLY 106651-0581 zexel genuine, new aftermarket engine parts with delivery

Service parts 106651-0581 INJECTION-PUMP ASSEMBLY:

1. _

2. FUEL INJECTION PUMP 106065-1230

3. GOVERNOR 105306-0631

4. SUPPLY PUMP 105227-1030

5. AUTOM. ADVANCE MECHANIS 105614-4210

6. COUPLING PLATE 105662-0761

7. COUPLING PLATE

8. _

9. _

10. NOZZLE AND HOLDER ASSY 105100-4500

11. Nozzle and Holder

12. Open Pre:MPa(Kqf/cm2) 19.6(200)

13. NOZZLE-HOLDER 105031-4370

14. NOZZLE

105015-4090

15. NOZZLE SET

Include in #1:

106651-0581 as INJECTION-PUMP ASSEMBLY

Cross reference number

Zexel num

Bosch num

Firm num

Name

106651-0581

INJECTION-PUMP ASSEMBLY

Information:

There are two water temperature regulators, one for each cylinder head.1. Drain the coolant from the engine to a level below the water temperature regulators.
Typical Example2. Remove elbow (1). Remove tube and elbow (2). 3. Remove cover assemblies (3). 4. Remove water temperature regulator (4) from each cover assembly. 5. Remove lip-type seal (5) from each cover assembly if a replacement is necessary.6. Check the water temperature regulators. See Specifications Manual SENR6475. The following steps are for the installation of the water temperature regulators. 7. Use Tool (A) to install lip-type seals (5). Install the seals with the lip toward the inside of the covers. Install the seal until it contacts the counterbore in the cover assembly.
If the water temperature regulators are installed incorrectly the engine will over heat.
8. Put clean glycerin on the lip of seal (5), and install water temperature regulator (4) in each cover assembly (3). 9. Install new gaskets (6) and cover assemblies (3).
Typical Example10. Install the gaskets and elbow (1). Put clean engine oil or glycerin on the O-ring seals on tube (2). Install the gasket, tube and elbow (2).11. Fill the cooling system to the correct level. See the Operation & Maintenance Manual.