104304-3161 ZEXEL 9 400 610 148 BOSCH INJECTION-PUMP ASSEMBLY 9400610148 1043043161 5156014142

Information injection-pump assembly

BOSCH 9 400 610 148 9400610148

ZEXEL 104304-3161 1043043161

ISUZU 5156014142 5156014142

Price: query

Buy now
Add to cart Go to cart

Rating:

Buy INJECTION-PUMP ASSEMBLY 104304-3161 zexel genuine, new aftermarket engine parts with delivery

Service parts 104304-3161 INJECTION-PUMP ASSEMBLY:

1. _

2. FUEL INJECTION PUMP 104300-4211

3. GOVERNOR

4. SUPPLY PUMP 105248-0230

5. AUTOM. ADVANCE MECHANIS

6. COUPLING PLATE

7. COUPLING PLATE

8. _

9. _

10. NOZZLE AND HOLDER ASSY 105141-2061

11. Nozzle and Holder 8-94220-084-3

12. Open Pre:MPa(Kqf/cm2) 11.8{120}

13. NOZZLE-HOLDER 105071-1380

14. NOZZLE 105000-1770

15. NOZZLE SET

Include in #1:

104304-3161 as INJECTION-PUMP ASSEMBLY

Cross reference number

Zexel num

Bosch num

Firm num

Name

104304-3161

9 400 610 148

5156014142 ISUZU

INJECTION-PUMP ASSEMBLY
4FA1 * K

Information:

There are two water temperature regulators, one for each cylinder head.1. Drain the coolant from the engine to a level below the water temperature regulators.
Typical Example2. Remove elbow (1). Remove tube and elbow (2). 3. Remove cover assemblies (3). 4. Remove water temperature regulator (4) from each cover assembly. 5. Remove lip-type seal (5) from each cover assembly if a replacement is necessary.6. Check the water temperature regulators. See Specifications Manual SENR6475. The following steps are for the installation of the water temperature regulators. 7. Use Tool (A) to install lip-type seals (5). Install the seals with the lip toward the inside of the covers. Install the seal until it contacts the counterbore in the cover assembly.
If the water temperature regulators are installed incorrectly the engine will over heat.
8. Put clean glycerin on the lip of seal (5), and install water temperature regulator (4) in each cover assembly (3). 9. Install new gaskets (6) and cover assemblies (3).
Typical Example10. Install the gaskets and elbow (1). Put clean engine oil or glycerin on the O-ring seals on tube (2). Install the gasket, tube and elbow (2).11. Fill the cooling system to the correct level. See the Operation & Maintenance Manual.