104303-4181 ZEXEL 9 400 616 486 BOSCH INJECTION-PUMP ASSEMBLY 9400616486 1043034181 131016881

Information injection-pump assembly

BOSCH 9 400 616 486 9400616486

ZEXEL 104303-4181 1043034181

ISHIKAWAJIMA-S 131016881 131016881

Price: query

Buy now
Add to cart Go to cart

Rating:

Buy INJECTION-PUMP ASSEMBLY 104303-4181 zexel genuine, new aftermarket engine parts with delivery

Service parts 104303-4181 INJECTION-PUMP ASSEMBLY:

1. _

2. FUEL INJECTION PUMP 104300-3391

3. GOVERNOR

4. SUPPLY PUMP 105248-0160

5. AUTOM. ADVANCE MECHANIS

6. COUPLING PLATE

7. COUPLING PLATE

8. _

9. _

10. NOZZLE AND HOLDER ASSY 105141-1792

11. Nozzle and Holder 13140 60 62

12. Open Pre:MPa(Kqf/cm2) 11.8{120}

13. NOZZLE-HOLDER 105071-0542

14. NOZZLE

105000-1600

15. NOZZLE SET

Include in #1:

104303-4181 as INJECTION-PUMP ASSEMBLY

Cross reference number

Zexel num

Bosch num

Firm num

Name

104303-4181

9 400 616 486

131016881 ISHIKAWAJIMA-S

INJECTION-PUMP ASSEMBLY
H843 * K 14BV PES3K PE

Information:

There are two water temperature regulators, one for each cylinder head.1. Drain the coolant from the engine to a level below the water temperature regulators.
Typical Example2. Remove elbow (1). Remove tube and elbow (2). 3. Remove cover assemblies (3). 4. Remove water temperature regulator (4) from each cover assembly. 5. Remove lip-type seal (5) from each cover assembly if a replacement is necessary.6. Check the water temperature regulators. See Specifications Manual SENR6475. The following steps are for the installation of the water temperature regulators. 7. Use Tool (A) to install lip-type seals (5). Install the seals with the lip toward the inside of the covers. Install the seal until it contacts the counterbore in the cover assembly.
If the water temperature regulators are installed incorrectly the engine will over heat.
8. Put clean glycerin on the lip of seal (5), and install water temperature regulator (4) in each cover assembly (3). 9. Install new gaskets (6) and cover assemblies (3).
Typical Example10. Install the gaskets and elbow (1). Put clean engine oil or glycerin on the O-ring seals on tube (2). Install the gasket, tube and elbow (2).11. Fill the cooling system to the correct level. See the Operation & Maintenance Manual.