Information injection-pump assembly
BOSCH
9 400 616 158
9400616158
ZEXEL
101696-9884
1016969884
NISSAN-DIESEL
16713Z6962
16713z6962
Rating:
Service parts 101696-9884 INJECTION-PUMP ASSEMBLY:
1.
_
7.
COUPLING PLATE
8.
_
9.
_
11.
Nozzle and Holder
12.
Open Pre:MPa(Kqf/cm2)
16.7(170)/19.6(200)
14.
NOZZLE
Cross reference number
Zexel num
Bosch num
Firm num
Name
101696-9884
9 400 616 158
16713Z6962 NISSAN-DIESEL
INJECTION-PUMP ASSEMBLY
FE6TA K 14BF INJECTION PUMP ASSY PE6AD PE
FE6TA K 14BF INJECTION PUMP ASSY PE6AD PE
Information:
To avoid damage to electronic components, do not remove the processor from the SLC 5/04 Chassis until all power is removed from the power supply.Do not expose memory modules to surfaces or areas that may typically hold an electrostatic charge.
Disconnect the power supply.
Press the retaining clips at the top of the processor and press the retaining clips at the bottom of the processor.
Grasp the connector with your thumb and index finger. Lift up on the ends of the carrier.
When the end is partially raised, begin lifting the other end in the same manner. Repeat 4 until the memory module has been removed.
Place the new module on the connector. Press the module in place.
To avoid potential damage to the processor, handle all modules by the ends of the carrier or edges of the plastic housing. Skin oil or dirt can corrode metallic surfaces, inhibiting electrical contact.
Align the processor and the guides in the chassis.
Gently slide the processor in the chassis. Secure the top retainer clips and secure the bottom retainer clips.
Install a wire tie in order to secure your wiring.
Cover any unused slots. This protects the chassis.
Illustration 1 g00563306
Verify that the new memory module corrects the problem.
Have questions with 101696-9884?
Group cross 101696-9884 ZEXEL
Nissan-Diesel
Nissan-Diesel
101696-9884
9 400 616 158
16713Z6962
INJECTION-PUMP ASSEMBLY
FE6TA
FE6TA