101608-9590 ZEXEL F 019 Z10 120 BOSCH INJECTION-PUMP ASSEMBLY f019z10120 1016089590 1671395306


 

Information injection-pump assembly

BOSCH F 019 Z10 120 f019z10120
ZEXEL 101608-9590 1016089590
NISSAN-DIESEL 1671395306 1671395306
101608-9590 INJECTION-PUMP ASSEMBLY
Rating:
71
Buy INJECTION-PUMP ASSEMBLY 101608-9590 zexel genuine, new aftermarket engine parts with delivery

Service parts 101608-9590 INJECTION-PUMP ASSEMBLY:

1. _
2. FUEL INJECTION PUMP 101060-5350
3. GOVERNOR 105921-8590
4. SUPPLY PUMP 105220-7060
5. AUTOM. ADVANCE MECHANIS 105672-0720
6. COUPLING PLATE 105662-1630
7. COUPLING PLATE
8. _
9. _
10. NOZZLE AND HOLDER ASSY 105160-4120
11. Nozzle and Holder 1660095019
12. Open Pre:MPa(Kqf/cm2) 19.6{200}
13. NOZZLE-HOLDER 105031-4620
14. NOZZLE 105025-0130
15. NOZZLE SET

Include in #1:

101608-9590 as INJECTION-PUMP ASSEMBLY

Include in #2:

Cross reference number

Zexel num
Bosch num
Firm num
Name
101608-9590 
101608-9591 
F 019 Z10 120 
1671395306  NISSAN-DIESEL
INJECTION-PUMP ASSEMBLY
NE6TA * K 14BF PE6AD PE




Information:

Cautions Regarding Battery* Handle Battery Carefully * Never use flames or allow sparks near the battery. The battery releases flammable hydrogen gas and oxygen gas. These gases can be ignited by flames and cause an explosion.* Do not use the battery when the fluid surface is lower than the minimum level. Using a battery with a low electrolyte level can result in an explosion.* Do not short the battery terminals with a tool or other metal object.* When disconnecting battery cables, always remove the cable from the negative (-) terminal first. When reconnecting cables, attach the cable to the positive (+) terminal first.* Charge the battery in a well-ventilated area, with all filling hole plugs removed.* Make sure the cable clamps are securely installed on the battery terminals. A loose cable clamp can cause sparks that may result in explosion.* Before servicing electrical components or conducting electrical welding, set the battery switch to the [Open/OFF] position or disconnect the cable from the negative (-) battery terminal to cut off the electrical current.* Electrolyte (battery fluid) contains dilute sulfuric acid. Careless handling of the battery can lead to the loss of sight and/or burns. Also, do not swallow electrolyte.* Wear protective goggles and rubber gloves when maintaining and inspecting the battery (when adding water, charging, etc.).* If electrolyte is spilled onto the skin or clothes, immediately wash with lots of clean fresh water and thoroughly clean with soap.* If electrolyte gets into eyes, immediately flush with lots of clean fresh water and seek immediate medical attention.* Should you accidentally swallow electrolyte, gargle with plenty of water, then drink lots of water, and seek immediate medical attention.
Response To Abnormalities* If Engine Overheats, Conduct Heating Operation Before Stopping The Engine If the engine overheats, do not stop the engine immediately. Abruptly stopping an overheated engine may cause the coolant temperature to rise, resulting in seizing of the engine. If the engine overheats, operate the engine at low idling speed (cooling temperature), and stop the engine after the coolant temperature lowers sufficiently.Do not add coolant immediately after stopping the engine. Adding coolant to a hot engine may cause damage to the cylinder heads due to sudden change in temperature. Add coolant after the engine cools to room temperature.* If Engine Stops Due To Abnormality, Exercise Caution When Restarting If the engine stops due to an abnormality, do not restart the engine immediately. If the engine stops with an alarm, check and correct the cause of the problem before restarting. Operating the engine without correcting the problem may result in serious engine problems.* If Oil Pressure Drops, Stop Engine Immediately If the engine oil pressure decreases, stop the engine immediately, and inspect the lubrication system. Operating the engine with low oil pressure may cause seizing of the bearings and other parts.* If Fan Belt Breaks, Stop Engine Immediately If the fan belt breaks, stop the engine immediately. Continued operation of the engine without the fan belt causes coolant to change to steam and

Have questions with 101608-9590?





Group cross 101608-9590 ZEXEL

Dpico 

 
 
INJECTION-PUMP ASSEMBLY
6D16
 
 
INJECTION-PUMP ASSEMBLY
L7

Nissan-Diesel 

9 400 610 770 
16713Z6330 
INJECTION-PUMP ASSEMBLY
FE6B

Dpico 

 
 
INJECTION-PUMP ASSEMBLY
D1146TI
 
 
INJECTION-PUMP ASSEMBLY
D1146TI

Nissan-Diesel 

 
16713Z6804 
INJECTION-PUMP ASSEMBLY
FE6A
9 400 615 877 
16713Z6879 
INJECTION-PUMP ASSEMBLY
FE6A
 
16713Z6808 
INJECTION-PUMP ASSEMBLY
FE6E
9 400 615 878 
16713Z6877 
INJECTION-PUMP ASSEMBLY
FE6E
 
16713Z6805 
INJECTION-PUMP ASSEMBLY
FE6E
9 400 615 879 
16713Z6876 
INJECTION-PUMP ASSEMBLY
FE6E
9 400 611 521 
16713Z6806 
INJECTION-PUMP ASSEMBLY
MD92

Dpico 

 
 
INJECTION-PUMP ASSEMBLY
L7A
 
 
INJECTION-PUMP ASSEMBLY
L7A
 
 
INJECTION-PUMP ASSEMBLY
L7A

Nissan-Diesel 

101608-9590  

101608-9591 
F 019 Z10 120 
1671395306 
INJECTION-PUMP ASSEMBLY
NE6TA
9 400 615 880 
1671395315 
INJECTION-PUMP ASSEMBLY
NE6TA
Back to top