Information injection-pump assembly
BOSCH
9 400 615 800
9400615800
ZEXEL
101608-1452
1016081452
MITSUBISHI
ME078429
me078429
Rating:
Service parts 101608-1452 INJECTION-PUMP ASSEMBLY:
1.
_
6.
COUPLING PLATE
7.
COUPLING PLATE
8.
_
9.
_
11.
Nozzle and Holder
ME078365
12.
Open Pre:MPa(Kqf/cm2)
15.
NOZZLE SET
Cross reference number
Zexel num
Bosch num
Firm num
Name
101608-1452
9 400 615 800
ME078429 MITSUBISHI
INJECTION-PUMP ASSEMBLY
6D16T K
6D16T K
Information:
Lubricate, Oil - To apply a material to a surface to reduce
Pry - To raise, move or open with a lever.
Remove - To take off.
Route - To install a harness, hose, or wire along a specific course or layout along or through a product, to direct along a predefined path.
Special Tool - To work with a nonstandard device.
Tighten - To make nearer to fully stretched, without slack, to apply tension or torque.Torque Specifications
Refer to Torque Specifications, SENR3130 for the most up-to-date torque specifications for standard fasteners.Tooling Required
The table below contains the tooling needed for this procedure.
Table 39
Item Qty Part Number Part Name Illustration (Substep) Location
T1 1 5F-4764 Pry Bar Illustration 6 (1) Fuel Injector Removal
Illustration 2 g06285426
Illustration 3 g06285429
Illustration 4 g06285477
Illustration 5 g06285492
Illustration 6 g06285497Fuel Injector Installation
Illustration 7 g06285503
Illustration 8 g06285515
Illustration 9 g06285527
Illustration 10 g06285536
Refer to the appropriate Testing and Adjusting manual to check or reset the engine valve lash.
Illustration 11 g06285542Reference Section
Pry - To raise, move or open with a lever.
Remove - To take off.
Route - To install a harness, hose, or wire along a specific course or layout along or through a product, to direct along a predefined path.
Special Tool - To work with a nonstandard device.
Tighten - To make nearer to fully stretched, without slack, to apply tension or torque.Torque Specifications
Refer to Torque Specifications, SENR3130 for the most up-to-date torque specifications for standard fasteners.Tooling Required
The table below contains the tooling needed for this procedure.
Table 39
Item Qty Part Number Part Name Illustration (Substep) Location
T1 1 5F-4764 Pry Bar Illustration 6 (1) Fuel Injector Removal
Illustration 2 g06285426
Illustration 3 g06285429
Illustration 4 g06285477
Illustration 5 g06285492
Illustration 6 g06285497Fuel Injector Installation
Illustration 7 g06285503
Illustration 8 g06285515
Illustration 9 g06285527
Illustration 10 g06285536
Refer to the appropriate Testing and Adjusting manual to check or reset the engine valve lash.
Illustration 11 g06285542Reference Section
Have questions with 101608-1452?
Group cross 101608-1452 ZEXEL
Mitsubishi
Mitsubishi
Mitsubishi
101608-1452
9 400 615 800
ME078429
INJECTION-PUMP ASSEMBLY
6D16T
6D16T