Information injection-pump assembly
BOSCH
9 400 614 702
9400614702
ZEXEL
101602-0431
1016020431
ISUZU
5156010764
5156010764
Rating:
Service parts 101602-0431 INJECTION-PUMP ASSEMBLY:
1.
_
5.
AUTOM. ADVANCE MECHANIS
6.
COUPLING PLATE
8.
_
9.
_
10.
NOZZLE AND HOLDER ASSY
11.
Nozzle and Holder
12.
Open Pre:MPa(Kqf/cm2)
18.1(185)
13.
NOZZLE-HOLDER
15.
NOZZLE SET
Cross reference number
Zexel num
Bosch num
Firm num
Name
101602-0431
9 400 614 702
5156010764 ISUZU
INJECTION-PUMP ASSEMBLY
6BD1 * K 14BE PE6A PE
6BD1 * K 14BE PE6A PE
Information:
Replacing a Power Supply
Disconnect the power supply.
To avoid damage to electronic components, do not remove the processor from the SLC 5/04 Chassis until all power is removed from the power supply.Do not expose memory modules to surfaces or areas that may typically hold an electrostatic charge.
Remove the two retaining screws that secure the power supply to the chassis.
Remove the power supply from the chassis.
To avoid potential damage to the processor, handle all modules by the ends of the carrier or edges of the plastic housing. Skin oil or dirt can corrode metallic surfaces, inhibiting electrical contact.
Align the new power supply and the guides in the chassis.
Gently slide the power supply in the chassis. Secure the top retainer clips and secure the bottom retainer clips.
Install the two retaining screws that secure the power supply to the chassis.
Install a wire tie in order to secure your wiring.
Cover any unused slots. This protects the chassis.
Illustration 1 g00563308
Verify that the new power supply corrects the problem.
Disconnect the power supply.
To avoid damage to electronic components, do not remove the processor from the SLC 5/04 Chassis until all power is removed from the power supply.Do not expose memory modules to surfaces or areas that may typically hold an electrostatic charge.
Remove the two retaining screws that secure the power supply to the chassis.
Remove the power supply from the chassis.
To avoid potential damage to the processor, handle all modules by the ends of the carrier or edges of the plastic housing. Skin oil or dirt can corrode metallic surfaces, inhibiting electrical contact.
Align the new power supply and the guides in the chassis.
Gently slide the power supply in the chassis. Secure the top retainer clips and secure the bottom retainer clips.
Install the two retaining screws that secure the power supply to the chassis.
Install a wire tie in order to secure your wiring.
Cover any unused slots. This protects the chassis.
Illustration 1 g00563308
Verify that the new power supply corrects the problem.
Have questions with 101602-0431?
Group cross 101602-0431 ZEXEL
Isuzu
101602-0431
9 400 614 702
5156010764
INJECTION-PUMP ASSEMBLY
6BD1
6BD1