101401-9146 ZEXEL 9 400 610 426 BOSCH INJECTION-PUMP ASSEMBLY 9400610426 1014019146 tf2013800e

Information injection-pump assembly

BOSCH 9 400 610 426 9400610426

ZEXEL 101401-9146 1014019146

MAZDA TF2013800E tf2013800e

Price: query

Buy now
Add to cart Go to cart

Rating:

Buy INJECTION-PUMP ASSEMBLY 101401-9146 zexel genuine, new aftermarket engine parts with delivery

Service parts 101401-9146 INJECTION-PUMP ASSEMBLY:

1. _

2. FUEL INJECTION PUMP 101040-9882

3. GOVERNOR 105921-5962

4. SUPPLY PUMP 105210-6280

5. AUTOM. ADVANCE MECHANIS 105671-0081

6. COUPLING PLATE

7. COUPLING PLATE

8. _

9. _

10. NOZZLE AND HOLDER ASSY 105118-4871

11. Nozzle and Holder TF01 13 H50

12. Open Pre:MPa(Kqf/cm2) 19.6{200}

13. NOZZLE-HOLDER 105048-3450

14. NOZZLE 105017-0861

15. NOZZLE SET

Include in #1:

101401-2341 as _

101401-2342

101401-9146 as INJECTION-PUMP ASSEMBLY

Cross reference number

Zexel num

Bosch num

Firm num

Name

101401-9146

9 400 610 426

TF2013800E MAZDA

INJECTION-PUMP ASSEMBLY
TF K

Information:

There are two water temperature regulators, one for each cylinder head.1. Drain the coolant from the engine to a level below the water temperature regulators.
Typical Example2. Remove elbow (1). Remove tube and elbow (2). 3. Remove cover assemblies (3). 4. Remove water temperature regulator (4) from each cover assembly. 5. Remove lip-type seal (5) from each cover assembly if a replacement is necessary.6. Check the water temperature regulators. See Specifications Manual SENR6475. The following steps are for the installation of the water temperature regulators. 7. Use Tool (A) to install lip-type seals (5). Install the seals with the lip toward the inside of the covers. Install the seal until it contacts the counterbore in the cover assembly.
If the water temperature regulators are installed incorrectly the engine will over heat.
8. Put clean glycerin on the lip of seal (5), and install water temperature regulator (4) in each cover assembly (3). 9. Install new gaskets (6) and cover assemblies (3).
Typical Example10. Install the gaskets and elbow (1). Put clean engine oil or glycerin on the O-ring seals on tube (2). Install the gasket, tube and elbow (2).11. Fill the cooling system to the correct level. See the Operation & Maintenance Manual.