148530-2921 ZEXEL 9 461 626 080 BOSCH GOVERNOR ; ELECTRIC 9461626080 1485302921


 

Information governor ; electric

BOSCH 9 461 626 080 9461626080
ZEXEL 148530-2921 1485302921
148530-2921 GOVERNOR ; ELECTRIC
Rating:
20
Buy GOVERNOR ; ELECTRIC 148530-2921 zexel genuine, new aftermarket engine parts with delivery

Include in ###:

Number on scheme 505
GOVERNOR;ELECTRIC
1047013041 as GOVERNOR;ELECTRIC

Cross reference number

Zexel num
Bosch num
Firm num
Name
148530-2921 
9 461 626 080 
   
GOVERNOR ; ELECTRIC
C 74HJ GOVERNOR;ELECTRIC FUN GEA




Information:

1. Disconnect water supply hose from water pump inlet.2. Remove connector pipe (1), remove two bolts (2) and remove oil fill pipe (3). 3. Remove bolts (4) and (5) then remove the water pump. The following steps are for the installation of the water pump.4. Position the water pump and install two bolts (4) and (5). Tighten the two bolts evenly.5. Position connector pipe (1) and gaskets then install the bolts.6. Install oil fill pipe (3). Be sure the gasket is in position between the regulator and pipe and install bolts (2).End By:a. Install alternatorb. Fill the cooling system to the specified level. See the Maintenance ManualDisassemble & Assemble Water Pump
Start By:a. remove water pump 1. Remove three bolts (1) and remove cover (2). 2. Use an M12 X 1.75 bolt to force impeller (3) from shaft (4). Install forcing bolt in impeller as indicated by arrow. Hold impeller and screw bolt in until impeller comes off shaft. 3. Remove bolt (5), washer (6), bearing (7) and gear (8). 4. Remove three bolts (9) and remove cover (10) with bearing (11). 5. Press shaft (4) out of seal (12).
Do not allow shaft (4) to fall to the floor, damage may occur to the shaft.
6. Remove seal (12) and seal (13) from water pump housing. The following steps are for the assembly of the water pump. 7. Using driver group, install seal (13). Refer to illustration to see direction of seal lip. Lubricate shaft seal area with engine oil.8. Assemble shaft (4), bearing (11) and cover (10). Position assembly into seal and housing then install bolts (9). 9. Position the housing and shaft assembly in a press. Position seal (12) on shaft (4). 10. Position tool (A) and press seal into place. 11. Position the water pump in a press, position impeller (3) and press it into place. Dimension X is 1.5 0.5 mm (.059 .020 in).12. Position seal and cover (2), then install bolts (1).End By:a. install water pump

Have questions with 148530-2921?





Group cross 148530-2921 ZEXEL

9 461 619 091 
 
GOVERNOR ; ELECTRIC
148530-2921  
9 461 626 080 
 
GOVERNOR ; ELECTRIC
Back to top