105923-0041 ZEXEL F 01G 29N 036 BOSCH GOVERNOR f01g29n036 1059230041

This Revised Service Letter replaces the 05Dec2012 (Revised 31Jan2013) Service Letter. Changes have been made to the Affected Product and Action Required.
TERMINATION DATE
31Dec2013
PROBLEM
The existing fuel injector has a 150 degree spray pattern. During the combustion stroke (process), the current end of injection timing maps can allow the 150 degree spray pattern to temporarily impinge upon the exposed wall of the cylinder liner as the piston moves downward in the bore.
Depending on engine speed and load factors, the fuel making contact with the liner can dilute the oil film or cause excessive soot. The excessive soot can build up to form carbon deposits at the piston lands and grooves, resulting in uneven top ring and groove wear, which may cause ring breakage. This situation is aggravated by contamination within the air and lubrication systems.
AFFECTED PRODUCT
Model Identification Number
793D FDB00105-01737, 1739
PARTS NEEDED
Qty
Part Number Description
16 20R2296 INJECTOR GP-FUEL
1 4264383 SOFTWARE GP-ELEK
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 7% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
This program does not apply to 793D Off-Highway Trucks equipped with high altitude engine arrangements.
If a 793D Off-Highway Truck that is listed in the Affected Product already has 423-7547 Fuel Injectors or 20R-2296 Fuel Injectors installed, do not apply this Service Letter.
Refer to the service manual if/as necessary.
Install a full set of sixteen 145 degree fuel injectors along with the software.
NOTE 1: Do not mix the 145 degree fuel injectors with the former 150 degree fuel injectors in the same engine.
NOTE 2: Do not install the software that is listed in the Parts Needed unless all sixteen fuel injectors have been replaced by the 145 degree spray pattern fuel injectors that is listed in the Parts Needed.
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
0-1000 hrs,
0-6 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 8.0-hour job
If there has been a previous repair, part age/hours will apply. Retain a copy of the previous repair invoice in the dealer's records for audit purposes, and specify repair date and machine hours in the "Additional Comments" section of the warranty claim.
If the engine is out of chassis for Planned Component Rebuild (PCR), the software and injectors should be installed. However, the costs for the software and injector update are not covered under this program.
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.