105401-0650 ZEXEL 9 420 612 096 BOSCH GOVERNOR 9420612096 1054010650 223203720a

13. Install spring (16), bellcrank (17). and retaining ring (15) on cover assembly (14). 14. Install gasket (24) bellcrank assembly (14) and two bolts (13) on timing advance housing. 15. Install timing advance housing (11) on the timing gear cover. Remove the screwdriver. 16. Check the position (protusion) of ball detent (25) in tool (B). It should protrude only slightly into the grooved area. During the following steps, tool (B) and the area of installation cannot be seen. The cutaway views are shown for better photo illustration. 17. Install tool (B) with grooved side toward the engine, between the power piston bearing and bellcrank (17) so that ear (26) is in an approximate 9 o'clock position. 18. Apply slight hand pressure and push tool (B) towards the engine and rotate counterclockwise slowly until ear (27) is in an approximate 9 o'clock position. A slight resistance as the tool starts to seat can be felt.19. Continue to rotate tool (B) counterclockwise until ear (27) is in an approximate 6 o'clock position. 20. Carefully install timing position sensor (6), spring (28), damping washer (29), bracket (8), collar (10) and locknut (9). Do not tighten locknut (9) at this time.21. Connect the wiring harness from the timing position sensor to the wiring harness on the engine. (P7/J7 connector). Be sure that the wiring harness from the PEEC control module is connected to the engine wiring harness. (P2/J2 connector).22. Disconnect the PEEC data link connector (the short pigtail out of the top of the PEEC control module - (P1/J1 connector) from the truck wiring harness and connect either tool (C) or tool (D) to the PEEC data link connector (J1 connector). Damping washer (29) must be installed above the flange om sensor (6). The aluminum surface of the damping washer (29) faces collar (10).23. Turn power on to the PEEC control module. Select "Timing Position Sensor Calibration" the main menu of tool (C) or (D). See special Instructions, Form No's. SEHS8742 and/or SEHS8743.
Do not engage the starter, or damage to the engine will be the result.
24. Adjust collar (10) on timing position sensor until the bar graph on tool (C) or (D) is centered and indicate the timing position sensor is calibrated.25. Tighten locknut (9) to 55 7 N*m (41 5 lb.ft.).26. Check the timing position calibration reading on tool (C) or (D) to insure that the timing position sensor is still in calibration after tightening the locknut.27. Turn off power to the PEEC control module.28. Disconnect tool (C) or (D) from the PEEC control module. Connect the PEEC data link connector (J1 connector) to the truck harness (P1 connector).29. Remove tool (B) from between the power piston and the bellcrank.30. Use tool (E) to rotate the engine in the clockwise direction to release the pressure on tool (F). Remove tool (F). 31. Lubricate O-ring seal (31) with engine oil and install on timing solenoid (5).32. Install timing solenoid (5) into the timing advance housing. Be sure lever (32) is