146561-8122 ZEXEL 9 461 615 116 BOSCH FULCRUM LEVER 9461615116 1465618122


 

Information fulcrum lever

BOSCH 9 461 615 116 9461615116
ZEXEL 146561-8122 1465618122
146561-8122 FULCRUM LEVER
Rating:
81
Buy FULCRUM LEVER 146561-8122 zexel genuine, new aftermarket engine parts with delivery

Include in ###:

Number on scheme 95
FULCRUM LEVER
1047614056 as FULCRUM LEVER

Cross reference number

Zexel num
Bosch num
Firm num
Name
146561-8122 
9 461 615 116 
   
FULCRUM LEVER
C 11FV GOVERNOR LEVER parts(VE) Others




Information:

Below 0°C (32°F)
Ether is poisonous and flammable. Do not store replacement cylinders in living areas or in the operator's compartment.Do not smoke while changing ether cylinders.Use ether only in well ventilated areas.Use it with care to avoid fires.Keep the ether cylinders out of the reach of unauthorized persons.Avoid breathing of the vapors or repeated contact of ether with skin.Do not store cylinders in direct sunlight.Do not puncture or burn cylinders.Discard cylinders in a safe place.
Do not use excessive starting fluid during starting or after the engine is running. Engine damage can result. Do not crank the engine for more than 30 seconds. Allow 2 minutes for the starter to cool before cranking again.
Turn the battery disconnect switch (if equipped) OFF after the engine is stopped to prevent battery discharge, while starter motor is cooling.1. Repeat steps 1 through 4 in the "Above 0°C (32°F)" procedure.2. Try to start engine without ether. If it does not start, then use ether.3. While cranking the engine, spray starting fluid (ether) sparingly, into the engine air inlet or push the starting aid control switch and hold for three seconds (time required to fill chamber). Ether is injected when aid switch is released.Use additional starting fluid once every two seconds until engine runs smoothly.If oil pressure does not register within 15 seconds, stop the engine immediately to prevent damage.4. Do not apply load to the engine or increase engine speed until oil pressure and all temperature gauges reach operating temperature. Check all gauges during the warm-up period.For starting below -18°C (0°F), use of optional cold weather starting aids are recommended. A coolant heater or extra battery capacity may be required.Temperatures below -23°C (-10°F), consult your Caterpillar dealer or refer to the "Cold Weather Operation Guide," Form SEBU5338, available from your Caterpillar dealer.

Have questions with 146561-8122?





Group cross 146561-8122 ZEXEL

 
 
FULCRUM LEVER
9 461 616 164 
 
FULCRUM LEVER
146561-8122  
9 461 615 116 
 
FULCRUM LEVER
Back to top