108092-0050 ZEXEL FUEL-INJECTION PUMP Cross 1080920050 221004420a


 

Information fuel-injection pump

ZEXEL 108092-0050 1080920050
HINO 221004420A 221004420a
108092-0050 FUEL-INJECTION PUMP
Rating:
61
Buy FUEL-INJECTION PUMP 108092-0050 zexel genuine, new aftermarket engine parts with delivery

Cross reference number

Zexel num
Bosch num
Firm num
Name
108092-0050 
108092-0051 
 
221004420A  HINO
FUEL-INJECTION PUMP
* Q




Information:


Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
If possible, take the fuel injection pump to a clean work area.
Clean the outside surfaces of the fuel injection pump.
Illustration 1 g03117860
Typical example
Place a suitable container under the fuel injection pump to collect any fuel from the fuel injection pump. Use a suitable tool to loosen the drain plug (1). If necessary, retain the fuel collected for analysis if required.
Illustration 2 g03117878
Typical example
Use a suitable pair of pliers to remove the throttle return spring (2).Note: Care should be taken when the spring is removed.
Illustration 3 g03117896
Typical example
Loosen self-locking nut (3). Do not remove the nut.
Illustration 4 g03117916
Typical example
Use a suitable pair of pliers to lift and disconnect throttle spring (4). Remove self-locking nut (3), washer, upper retainer, spring, lower retainer, spacer, lever, and dust cap.Note: Care should be taken when the spring is removed.
Illustration 5 g03117938
Typical example
Remove four screws (6) in the governor cover (7). Gently push the throttle shaft (5) down into the cover (7).
Illustration 6 g03117956
Typical example
To inspect the internal components of the fuel injection pump, gently lift and rotate the cover (7).Note: The cover is still connected internally, if resistance is felt, lower the cover and move the cover backwards. Attempt to lift the cover again.
Inspect the internal components of the fuel injection pump. Refer to steps 9a and 9b.
Illustration 7 g03117961
Typical example
If good quality fuel is being used, the components will be clean. Refer to illustration 7. Take photographs of the identification plate of the fuel injection pump and any evidence found. Attach the photographs to support the claim story.
Illustration 8 g03118119
Typical example
Illustration 9 g03118121
Typical example
If the injection pump has been run with excessive water in the fuel, there will be signs of rust and oxidization of the steel components. Refer to illustration 8. Fuel with dirt ingress will show a build-up of dirt on the components. Refer to illustration 9.Note: Issues with the fuel injection pump that are due to dirt and water void Caterpillar warranty. Advise the customer on the correct fuel, maintenance, and fuel storage procedures. Refer to the relevant Operation and Maintenance Manual for more information.If the fuel injection pump shows signs that contaminated fuel is the root cause of the problem, the evidence can be shown to the customer immediately.After the fuel injection pump has been inspected, the fuel injection pump must not be used in service.Rebuild the fuel injection pump. Refer to steps 1 to 6
Lower the cover (7) back into position. Ensure the throttle shaft (5), has been returned to the original position.
Install the four screws (6) to the cover (7). Tighten the

Have questions with 108092-0050?





Group cross 108092-0050 ZEXEL

9 410 610 900 
 
FUEL-INJECTION PUMP
9 410 610 901 
 
FUEL-INJECTION PUMP

Mitsubishi 

 
ME738583 
FUEL-INJECTION PUMP
9 410 613 763 
ME738660 
FUEL-INJECTION PUMP
9 410 613 764 
ME738895 
FUEL-INJECTION PUMP
9 410 610 408 
NP-TC10HD120/72ARS2 
ME740066 
FUEL-INJECTION PUMP
 
ME738688 
FUEL-INJECTION PUMP
 
ME738893 
FUEL-INJECTION PUMP
 
ME740069 
FUEL-INJECTION PUMP

Hino 

108092-0050  

108092-0051 
 
221004420A 
FUEL-INJECTION PUMP
9 410 610 930 
221004421A 
FUEL-INJECTION PUMP
9 410 614 383 
221004422A 
FUEL-INJECTION PUMP
9 410 610 902 
 
FUEL-INJECTION PUMP

Hino 

9 410 610 518 
221004760A 
FUEL-INJECTION PUMP

Mitsubishi 

9 410 610 699 
NP-TC10HD120/72ARS2 
ME741641 
FUEL-INJECTION PUMP
9 410 613 765 
NP-TC10HD120/72ARS2 
ME742189 
FUEL-INJECTION PUMP
Back to top