Information fuel-injection pump
BOSCH
9 410 617 628
9410617628
ZEXEL
104264-5081
1042645081
DAIHATSU
E286430010BZ
e286430010bz

Rating:
Components :
0. | INJECTION-PUMP ASSEMBLY | 104264-5081 |
1. | _ | |
2. | FUEL INJECTION PUMP | |
3. | NUMBER PLATE | |
4. | _ | |
5. | CAPSULE | |
6. | ADJUSTING DEVICE | |
7. | NOZZLE AND HOLDER ASSY | |
8. | Nozzle and Holder | |
9. | Open Pre:MPa(Kqf/cm2) | |
10. | NOZZLE-HOLDER | |
11. | NOZZLE |
Scheme ###:
1. | [1] | 141054-6920 | PUMP HOUSING |
5. | [1] | 141176-4120 | PLUNGER-AND-BARREL ASSY |
7. | [1] | 141133-0500 | CAPSULE |
8. | [1] | 141403-1300 | GASKET |
12. | [1] | 141142-7720 | DELIVERY-VALVE ASSEMBLY |
20. | [1] | 141118-2000 | O-RING |
21. | [1] | 141119-3600 | FLANGE BUSHING |
22. | [6] | 141124-1300 | BLEEDER SCREW |
25. | [1] | 141482-9600 | O-RING |
50. | [1] | 141215-5402 | COMPRESSION SPRING |
51. | [1] | 141216-1800 | SLOTTED WASHER |
52. | [1] | 141217-5500 | SLOTTED WASHER |
53. | [1] | 141218-7920 | GUIDE |
55. | [1] | 141220-1200 | LOCKING WASHER |
60. | [1] | 141244-7800 | CONTROL RACK |
77. | [1] | 141241-7200 | CONTROL SLEEVE |
81. | [1] | 141245-2000 | POINTER |
82/1. | [0] | 023500-6210 | PLAIN WASHER D11&6.4T1.5 |
82/1. | [0] | 029300-6010 | PLAIN WASHER D11&6.4T0.8 |
82/1. | [0] | 029300-6020 | PLAIN WASHER D11&6.4T0.35 |
83. | [1] | 020006-1440 | BLEEDER SCREW M6P1L14 |
93. | [1] | 141402-2920 | EYE BOLT |
94. | [2] | 141403-1600 | GASKET |
110. | [1] | 141420-1200 | BLEEDER SCREW |
111. | [1] | 141403-1200 | GASKET |
160. | [1] | 141418-1400 | SET OF NUTS |
161. | [1] | 141403-1400 | GASKET |
162. | [1] | 141480-0900 | COVER |
163. | [1] | 029111-0010 | CAPSULE |
164. | [1] | 150934-0900 | GASKET |
Include in #2:
104264-5081
as INJECTION-PUMP ASSEMBLY
Cross reference number
Zexel num
Bosch num
Firm num
Name
104264-5081
E286430010BZ DAIHATSU
FUEL-INJECTION PUMP
K 24FX FUEL INJECTION PUMP PF-1GX PF
K 24FX FUEL INJECTION PUMP PF-1GX PF
Information:
These recommendations are subject to change without notice. Consult your local Cat dealer for the most up to date recommendations.
Diesel engines may burn a wide variety of fuels. These fuels are divided into two general groups. The two groups are called the preferred fuels and the permissible fuels.The preferred fuels provide maximum engine service life and performance. The preferred fuels are distillate fuels. These fuels are commonly called diesel fuel, furnace oil, gas oil, or kerosene. These fuels must meet the “Cat Specification for Distillate Diesel Fuel for Off-Highway Diesel Engines” found in this Special Publication, "Distillate Diesel Fuel" article.The permissible fuels are some crude oils, some blends of crude oil with distillate fuel, and some marine diesel fuel. These fuels are not suitable for use in all engine applications. The acceptability of these fuels for use is determined on a case by case basis. A complete fuel analysis is required. Consult your Cat dealer for further information. Biodiesel fuel is permissible for use in Cat engines. Follow all the recommendations and guidelines given in this Special Publication, "Biodiesel" article.Note: Except for some biodiesel, permissible fuels are not acceptable for use in on-highway applications.
Use of permissible fuels can result in higher maintenance costs and reduced engine service life.
Note: Use of fuels that do not meet at least the minimum performance recommendations and/or requirements may lead to lower compartment performance and/or compartment failure. Problems/failures that are caused by using fuels that do not meet the minimum recommended and/or required performance level are not Cat factory defects and therefore are NOT covered by the Cat warranty. The fuel supplier and customer are responsible.