156900-9400 ZEXEL 9 423 612 051 BOSCH FLANGE BUSHING 9423612051 1569009400 1686699408


 

Information flange bushing

BOSCH 9 423 612 051 9423612051
ZEXEL 156900-9400 1569009400
NISSAN-DIESEL 1686699408 1686699408
156900-9400 FLANGE BUSHING
Rating:
81
Buy FLANGE BUSHING 156900-9400 zexel genuine, new aftermarket engine parts with delivery

Include in ###:

Number on scheme 1/1
FLANGE BUSHING
1056914060 as FLANGE BUSHING

Cross reference number

Zexel num
Bosch num
Firm num
Name
156900-9400 
9 423 612 051 
1686699408  NISSAN-DIESEL
FLANGE BUSHING
C 14GQ FLANGE TIMER




Information:

Below 0°C (32°F)
Ether is poisonous and flammable. Do not store replacement cylinders in living areas or in the operator's compartment.Do not smoke while changing ether cylinders.Use ether only in well ventilated areas.Use it with care to avoid fires.Keep the ether cylinders out of the reach of unauthorized persons.Avoid breathing of the vapors or repeated contact of ether with skin.Do not store cylinders in direct sunlight.Do not puncture or burn cylinders.Discard cylinders in a safe place.
Do not use excessive starting fluid during starting or after the engine is running. Engine damage can result. Do not crank the engine for more than 30 seconds. Allow 2 minutes for the starter to cool before cranking again.
Turn the battery disconnect switch (if equipped) OFF after the engine is stopped to prevent battery discharge, while starter motor is cooling.1. Repeat steps 1 through 4 in the "Above 0°C (32°F)" procedure.2. Try to start engine without ether. If it does not start, then use ether.3. While cranking the engine, spray starting fluid (ether) sparingly, into the engine air inlet or push the starting aid control switch and hold for three seconds (time required to fill chamber). Ether is injected when aid switch is released.Use additional starting fluid once every two seconds until engine runs smoothly.If oil pressure does not register within 15 seconds, stop the engine immediately to prevent damage.4. Do not apply load to the engine or increase engine speed until oil pressure and all temperature gauges reach operating temperature. Check all gauges during the warm-up period.For starting below -18°C (0°F), use of optional cold weather starting aids are recommended. A coolant heater or extra battery capacity may be required.Temperatures below -23°C (-10°F), consult your Caterpillar dealer or refer to the "Cold Weather Operation Guide," Form SEBU5338, available from your Caterpillar dealer.

Have questions with 156900-9400?





Group cross 156900-9400 ZEXEL

Nissan-Diesel 

156900-9400  
9 423 612 051 
1686699408 
FLANGE BUSHING
Back to top