Information eye bolt
BOSCH
9 442 611 586
9442611586
ZEXEL
027608-1740
0276081740
ISHIKAWAJIMA-S
1312360900
1312360900
Rating:
Include in #1:
106891-1551
as _
Include in ###:
Cross reference number
Zexel num
Bosch num
Firm num
Name
027608-1740
9 442 611 586
1312360900 ISHIKAWAJIMA-S
EYE BOLT
D 90HY EYE BOLT Standard parts Others
D 90HY EYE BOLT Standard parts Others
Information:
9. If the engine oil pressure gauge does not register within 10 seconds, stop the engine by pulling up on the accelerator pedal. Have corrections made.10. Keep the engine at low idle until the systems are warm.11. Watch all gauges and indicators. They must have correct readings before moving the machine.Below 0°C (32°F)
1. Follow the steps under "Above 0°C (32°F)."
If the engine does not start after two attempts, use starting fluid. This will prevent excessive battery drain and starting motor overheating.Use starting fluid (ether) only while cranking the engine.Use sparingly, excessive ether can cause piston and ring damage.Ether is to be used for cold weather starting purposes only.
Keep batteries charged to a corrected specific gravity of 1.250 or above. Otherwise, an external electrical source may be required. 2. Use starting fluid while cranking the engine. Push the button located below the start switch, at two second intervals only. A metered amount of starting fluid (ether) is released each time the button is pushed.3. Use additional starting fluid every two seconds until the engine starts.4. Release the start switch when the engine starts. Continue to inject ether until the engine runs smoothly.For starting below - 18°C (0°F), use additional starting aids. A coolant
1. Follow the steps under "Above 0°C (32°F)."
If the engine does not start after two attempts, use starting fluid. This will prevent excessive battery drain and starting motor overheating.Use starting fluid (ether) only while cranking the engine.Use sparingly, excessive ether can cause piston and ring damage.Ether is to be used for cold weather starting purposes only.
Keep batteries charged to a corrected specific gravity of 1.250 or above. Otherwise, an external electrical source may be required. 2. Use starting fluid while cranking the engine. Push the button located below the start switch, at two second intervals only. A metered amount of starting fluid (ether) is released each time the button is pushed.3. Use additional starting fluid every two seconds until the engine starts.4. Release the start switch when the engine starts. Continue to inject ether until the engine runs smoothly.For starting below - 18°C (0°F), use additional starting aids. A coolant