Information cover sub-assy, ti
Rating:
Scheme ###:
| 000. | [01] | 09621-00310 | COVER SUB-ASSY, TI | 22790-64850 |
| 001. | [01] | 09621-80092 | COVER, TIMER | |
| 002. | [01] | 09648-50090 | THERMO-ELEMENT SUB | |
| 003. | [01] | 09604-90280 | O-RING | |
| 004. | [01] | 90567-28001 | RING, HOLE SNAP | |
| 005. | [01] | 09007-80121 | COVER | |
| 006. | [01] | 09645-10441 | SHAFT SUB-ASSY, AD | |
| 007. | [01] | 09627-30140 | WASHER, GOVERNOR T | 22378-64010 |
| 008. | [01] | 09604-90300 | O-RING | 22193-54770 |
| 008. | [01] | 94914-02910 | O-RING | 90099-14048 |
| 009. | [01] | 94919-25581 | COLLAR, STEEL | |
| 010. | [01] | 09644-40060 | SPRING, RETURN | |
| 011. | [01] | 09644-40070 | SPRING, RETURN | |
| 012. | [01] | 09644-50042 | GUIDE, RETURN SPRI | |
| 013. | [01] | 09643-60192 | LEVER, ADJUSTING | |
| 014. | [01] | 94905-63320 | NUT | |
| 014. | [01] | 92156-08081 | NUT, FLANGE | |
| 015. | [01] | 91160-05041 | NUT, HEXAGON | 94115-40500 |
| 016. | [01] | 09266-40100 | SCREW, LEVER STOP |
Include in #3:
09600-02390
as COVER SUB-ASSY, TI
09621-00310
Cross reference number
| Part num | Firm num | Firm | Name |
| 09621-00310 | 22790-6485 | COVER SUB-ASSY, TI | |
| 22790-64850 | TOYOTA | COVER SUB-ASSY, TI |
Information:
Interfacing With a Shipyard
Provide table 3, table 4, table 7, table 8, and table 9.Provide the following list of information about the MMS configuration:
The MMS protocol for output is Modbus.
Ports for hardware are available. The ports have 9 pins. The RS-485 has one connection with 2 wires and two connections with 4 wires. The RS-232C has one handshaking connection and two connections without handshaking.
Provide the list of baud rates.
The network addresses can be a number between 1 and 247.
The system uses a serial cable that has 9 pins. The cable has shielding.Control System Inputs to PLC Redundant Relay Logic
Table 1
ISA TAG # PLC CARD # SENSOR DESCRIPTION PLC REG ASSIGN SIGNAL TYPE ALARM SHUT DOWN SETPOINT TRIP COMMENTS
PRESSURE CONTACTORS
PSLL-001 PLC01 Engine Low Oil Pressure: 144-0102 N7:01/07 DIGITAL X <
105 kPa (15.2 psi) Low Speed
PSLL-002 PLC01 Engine Low Oil Pressure: 144-0102 N7:01/07 DIGITAL X <
260 kPa (37.7 psi) High Speed
PSHH-003 PLC01 Engine High Crankcase Pressure: 117-1864 N7:07/11 DIGITAL X >
1 kPa (4.0 inch of H2O) Enable When Fuel is On
PSL-004 PLC02 Low Air Starting Pressure: 117-1864 N7:07/12 DIGITAL X <
750 kPa (108.8 psi) Removed if Transducer is Ordered
PSL-005 PLC02 Sea Water Low Pressure: N7:01/08 DIGITAL X <
35 kPa (5.1 psi) Removed if Transducer is Ordered
PSL-006 PLC02 Low Jacket Water Pressure: 144-0102 N7:01/10 DIGITAL X <
20 kPa (2.9 psi) (Low RPM)
<
35 kPa (5.1 psi) (High RPM) Removed if Transducer is Ordered
PSL-007 PLC02 Low AC/OC Circuit Water Pressure: 144-0102 N7:01/12 DIGITAL X <
35 kPa (5.1 psi) Removed if Transducer is Ordered
SWITCHES/MISC CONTACTS
YSL-001 PLC01 Low Battery Voltage: 7C-3508 N7:07/09 DIGITAL X < 22 VDC Monitors Dc to MMS
LSL-001 PLC02 Jacket Water Detection: 125-4340 N7:01/15 DIGITAL X Contact Close Energizes RJWDA Relay
HS-001 PLC01 Emergency Stop (Local) N7:07/06 DIGITAL X Contact Close Shuts Off Fuel And Air to Engine
SS-001 PLC01 Engine Speed Switch Crank Terminate: 100-5675 I:1.0/9 DIGITAL > 170 RPM & < 0 + 2 Sec
SS-006 Engine Speed Switch Alarm Time Delay: 100-5675 DIGITAL 9 Sec After SS-001 Enables Alarms and Shutdowns
SS-007 Engine Speed Switch Oil Pressure Step: 100-5675 DIGITAL 75%
Provide table 3, table 4, table 7, table 8, and table 9.Provide the following list of information about the MMS configuration:
The MMS protocol for output is Modbus.
Ports for hardware are available. The ports have 9 pins. The RS-485 has one connection with 2 wires and two connections with 4 wires. The RS-232C has one handshaking connection and two connections without handshaking.
Provide the list of baud rates.
The network addresses can be a number between 1 and 247.
The system uses a serial cable that has 9 pins. The cable has shielding.Control System Inputs to PLC Redundant Relay Logic
Table 1
ISA TAG # PLC CARD # SENSOR DESCRIPTION PLC REG ASSIGN SIGNAL TYPE ALARM SHUT DOWN SETPOINT TRIP COMMENTS
PRESSURE CONTACTORS
PSLL-001 PLC01 Engine Low Oil Pressure: 144-0102 N7:01/07 DIGITAL X <
105 kPa (15.2 psi) Low Speed
PSLL-002 PLC01 Engine Low Oil Pressure: 144-0102 N7:01/07 DIGITAL X <
260 kPa (37.7 psi) High Speed
PSHH-003 PLC01 Engine High Crankcase Pressure: 117-1864 N7:07/11 DIGITAL X >
1 kPa (4.0 inch of H2O) Enable When Fuel is On
PSL-004 PLC02 Low Air Starting Pressure: 117-1864 N7:07/12 DIGITAL X <
750 kPa (108.8 psi) Removed if Transducer is Ordered
PSL-005 PLC02 Sea Water Low Pressure: N7:01/08 DIGITAL X <
35 kPa (5.1 psi) Removed if Transducer is Ordered
PSL-006 PLC02 Low Jacket Water Pressure: 144-0102 N7:01/10 DIGITAL X <
20 kPa (2.9 psi) (Low RPM)
<
35 kPa (5.1 psi) (High RPM) Removed if Transducer is Ordered
PSL-007 PLC02 Low AC/OC Circuit Water Pressure: 144-0102 N7:01/12 DIGITAL X <
35 kPa (5.1 psi) Removed if Transducer is Ordered
SWITCHES/MISC CONTACTS
YSL-001 PLC01 Low Battery Voltage: 7C-3508 N7:07/09 DIGITAL X < 22 VDC Monitors Dc to MMS
LSL-001 PLC02 Jacket Water Detection: 125-4340 N7:01/15 DIGITAL X Contact Close Energizes RJWDA Relay
HS-001 PLC01 Emergency Stop (Local) N7:07/06 DIGITAL X Contact Close Shuts Off Fuel And Air to Engine
SS-001 PLC01 Engine Speed Switch Crank Terminate: 100-5675 I:1.0/9 DIGITAL > 170 RPM & < 0 + 2 Sec
SS-006 Engine Speed Switch Alarm Time Delay: 100-5675 DIGITAL 9 Sec After SS-001 Enables Alarms and Shutdowns
SS-007 Engine Speed Switch Oil Pressure Step: 100-5675 DIGITAL 75%