Information injector assy
Rating:
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
095000-5750 095000-5751 095000-5752 Common Rail Diesel Fuel Injector 8-97354811-0 Compatible for Isuzu D-MAX 4JJ1 8-97354811-1
FEMKFAXF Replacing fuel injectors promotes smooth engine operation and optimizes gas efficiency. || Accurate flow rate and original spray mode, achieving the best performance under driving conditions. || Manufacture, adaptation, form and function according to the original specifications of the automobile. || Accurate process design, matching the specifications of original parts, easy installation and saving time. || 095000-5750 095000-5751 095000-5752 Common Rail Diesel Fuel Injector 8-97354811-0 Compatible for Isuzu D-MAX 4JJ1 8-97354811-1
FEMKFAXF Replacing fuel injectors promotes smooth engine operation and optimizes gas efficiency. || Accurate flow rate and original spray mode, achieving the best performance under driving conditions. || Manufacture, adaptation, form and function according to the original specifications of the automobile. || Accurate process design, matching the specifications of original parts, easy installation and saving time. || 095000-5750 095000-5751 095000-5752 Common Rail Diesel Fuel Injector 8-97354811-0 Compatible for Isuzu D-MAX 4JJ1 8-97354811-1
Include in #3:
Cross reference number
| Part num | Firm num | Firm | Name |
| 09500-05752 | 8-97354811 | INJECTOR ASSY |
Information:
Keep all parts clean from contaminants. Contaminants put into the system may cause rapid wear and shortened component life.
1. Put compression on valve spring (2) with tool (A), and remove locks (1).2. Remove tool (A), rotocoil, spring, valve stem oil shield and valve. Put identification marks on valves with respect to their location in the cylinder head. 3. Check the spring force with tool (B). The spring force is 257 25 N (57.8 5.6 lb.). The length of spring under test force is 44.86 mm (1.766 in). The free length after test is 52.07 mm (2.050 in).4. Perform Steps 1 through 3 again for the remainder of the valves. The following steps are for the installation of the valves.5. Put clean engine oil on the valve stems. Install the valve, oil shield, spring (2) and rotocoil in the cylinder head. 6. Put tool (A) in position on the valve spring, and install the locks with tool (C).
Locks can be thrown from valve when the compressor is released if they are not in their correct position on valve stem. Personal injury can be the result if not carefully removed.
7. Remove tool (A), and hit the top of valve with a plastic hammer be sure the locks are in their correct position on valve.8. Do Steps 5 through 7 again for the remainder of the valves.End By:a. install spacer plate