09500-01201 INJECTOR ASSY Denso Cross


 

Information injector assy

09500-01201 INJECTOR ASSY
Rating:
65
Buy INJECTOR ASSY 09500-01201 genuine, new aftermarket engine parts with delivery

Components :

001. INJECTOR ASSY 09500-01201

Scheme ###:

000. [01] 09500-01201 INJECTOR ASSY ME300333
015. [01] 09003-40150 PLUG MM501732
016. [02] 94901-17590 WASHER, STEEL PLAT
017. [02] 94905-03370 NUT, HEXAGON
018. [01] 09001-40160 CAP, VALVE HOLDER
020. [01] 09508-70020 GUIDE, HARNESS
021. [01] 09508-90040 COVER, INJECTOR
022. [01] 09529-40190 HARNESS, INJECTOR

Include in #3:

09500-01201 as INJECTOR ASSY

Cross reference number



Part num Firm num Firm Name
09500-01201  ME300333  INJECTOR ASSY




Information:

START BY:a. remove valve coversb. remove rocker shaft assemblies and pushrodsc. remove fuel injection nozzles (earlier)
Be sure that the piston is at Top Center so that the valves will be held in position when the springs are removed.
1. Remove the valve cover bases.2. Remove the valve stem locks with tooling (A) using the following procedure: a. Install adapter plate (1) with two OS1618 (5/16-18 x 1 in.) bolts.b. Install stud (2) and nut (3). Tighten the nut. c. Install plate (4), washer (5) and nut (6). Tighten the nut until the locks are free.d. Remove locks (7), and remove the nut, washer and plate from the stud. Remove the stud and adapter plate from the fuel injection nozzle adapter. 3. Remove rotocoil (8), spring (9) and washer (10). 4. Use tool (B) to remove fuel injection nozzle adapter (11) from the cylinder head assembly. 5. Remove washers (12) and seals (13) from adapters (11).Install Fuel Injection Nozzle Adapters (Earlier)
1. Inspect seals (3) for damage or wear, and make a replacement if necessary.2. Install washers (1) and seals (3) on adapters (2).3. Put liquid soap in the bores of the cylinder head and on the seals of the fuel injection nozzle adapters.4. Put 5P3931 Anti-Seize Compound on the threads of adapter (2), and install the adapters in the cylinder head assembly. 5. Use tool (A), and tighten the adapters to a torque of 205 14 N m (150 10 lb.ft.). 6. Install washers (6), springs (5) and rotocoils (4). 7. Use tool (B), and compress the springs until locks (7) can be installed. Install locks (7) on the valve stems, and remove tool (B).8. Install the valve cover base. Tighten the valve cover base mounting bolts to a torque of 14 3 N m (10 2 lb.ft.).END BY:a. install fuel injection nozzles (earlier)b. install rocker shaft assemblies and push rodsc. install valve covers

Have questions with 09500-01201?





Group cross 09500-01201

Back to top