09250-01251 COUPLING ASSY Denso Cross


 

Information coupling assy

09250-01251 COUPLING ASSY
Rating:
47
Buy COUPLING ASSY 09250-01251 genuine, new aftermarket engine parts with delivery

Scheme ###:

000. [01] 09250-01251 COUPLING ASSY 1-15780200-02
001. [01] 09241-50980 FLANGE, COUPLING
002. [01] 09243-70320 COUPLING, CROSS
003. [02] 09246-00110 PLATE SUB-ASSY, CO
004. [02] 09243-30180 BOLT, HEXAGON
005. [06] 94904-06361 BOLT, HEXAGON
006. [01] 09243-30150 BOLT, HEXAGON
007. [02] 09243-10181 NUT, COUPLING FLAN

Include in #3:

09250-01251 as COUPLING ASSY

Cross reference number



Part num Firm num Firm Name
09250-01251  1-15780200  COUPLING ASSY




Information:

1. Disconnect hose (1) at governor control cylinder (2).2. Remove pin (4).3. Remove governor control cylinder (2).4. Note the position of linkage (3) in the lever, and remove linkage (3). The following steps are for installation of the governor control cylinder.5. Adjust linkage (3) so the distance between rod end centers is 84.07 mm (3.309 in).6. Install linkage (3) in its original position in the lever.7. Be sure lever (5) on the governor shaft is at 15 degrees from vertical (CW when viewed from the left side of the machine) with engine at low idle.8. Install control cylinder (2). Install pin (4) through link (3) and lever (5).9. Connect hose (1) to governor control cylinder (2).10. Adjust linkage (3) so lever (5) is at low idle when governor control cylinder is fully retracted.Disassemble & Assemble Governor Control Cylinder
Start By:a. remove governor control cylinder 1. Remove cover (1).
A spring force of 44.5 N (10 lb) will be released when the bolt that holds piston (8) is removed. Hold the components of the governor control cylinder to prevent unexpected movement of components and personal injury.
2. Remove the bolt that holds piston (6), and remove the piston and springs.3. Remove O-ring seal (2) and sleeve (5).4. Remove seals (3) and (4) from piston (6). The following steps are for the assembly of the governor control cylinder.5. Install lip-type seal (3) and "T" seal on the piston (6). Install the lip-type seal with the lip facing the cylinder pressure source.6. Install shell (5) in the air chamber body.7. Put 5P-0960 Multipurpose Grease inside the shell.8. Carefully install piston (6) and springs into the air chamber body.9. Install the bolt to hold the piston.10. Install O-ring seal (2) and cover (1).End By:a. install governor control cylinder

Have questions with 09250-01251?





Group cross 09250-01251

Back to top