09200-05260 ASSY Nzl Denso Cross


 

Information assy nzl

Nozzle: 0935007800
09200-05260 ASSY Nzl
Rating:
35
Buy ASSY Nzl 09200-05260 genuine, new aftermarket engine parts with delivery

KIT List:

Body assy, injecti 1904400380
Governor assy, mec NO APPLICATION

Components :

001. PUMP ASSY, INJECTI 09200-05260
001. PUMP ASSY, INJECTI 09200-05260
002. PUMP ASSY, FUEL FE 09210-03420
003. COUPLING ASSY 09250-01320
004. BODY ASSY, INJECTI 19010-01930
005. GOVERNOR ASSY, MEC 19080-06960
006. COMPENSATOR SUB-AS 19260-01620

Cross reference number



Part num Firm num Firm Name
09200-05260    ASSY Nzl
N59-12810-00    YAMAHA PUMP ASSY, INJECTI
N59-12810-01    YAMAHA PUMP ASSY, INJECTI




Information:

1. Remove oil supply tube (1) and suction bell and tube (2). 2. Remove bolts (3) that hold the oil pump to the cylinder block, and remove oil pump (4). The following steps are for installation of the oil pump.3. Put oil pump (4) in position on the cylinder block. Install the bolts that hold the oil pump to the cylinder block.4. Put clean engine oil on the O-ring seals of the tubes.5. Install oil supply tube (1) and suction bell and tube (2).End By:a. install oil panDisassemble Oil Pump
Start By:a. remove oil pump1. Remove the bolt and washer that hold the gear on the shaft. 2. Use tooling (A), and remove drive gear (1) from the shaft. Remove the key from the shaft. 3. Remove retainer (3) for the bypass valve.4. Remove the spring and bypass valve.5. Remove cover (2) from the pump body. 6. Use tooling (B), and remove the bearings from the cover. 7. Remove gears (5) and (6) from pump body (4).8. Use tooling (B), and remove the bearings from pump body (4).Assemble Oil Pump
1. Use tooling (B) to install the bearings in the pump body. Install the bearings so the joint in the bearings is 30° 15° from the center line of the oil pump outlet passage (7). 2. Install idler gear (5) and drive gear (6) in the oil pump body. Put clean engine oil on the bearings and the gears. 3. Use tooling (B), and install the bearings in cover (2). Install the bearings so the joint in the bearings is 30° 15° from the center line of the bearing bores toward oil pump outlet passage (7).4. Install bypass valve (8), spring (9) and the retainer.5. Install the key on the shaft. 6. Install gear (1) on the shaft. Install the washer and bolt that hold the gear on the shaft. Be sure the pump turns freely after assembly.End By:a. install oil pump

Have questions with 09200-05260?





Group cross 09200-05260

Back to top