09200-01890 PUMP ASSY, INJECTI Denso Cross


 

Information pump assy, injecti

Nozzle: 0935005880
09200-01890 PUMP ASSY, INJECTI
Rating:
4
Buy PUMP ASSY, INJECTI 09200-01890 genuine, new aftermarket engine parts with delivery

KIT List:

Pump assy, fuel fe 1922900060
Body assy, injecti 1904400320
Governor assy, mec 1908900170

Components :

001. PUMP ASSY, INJECTI 09200-01890
002. PUMP ASSY, FUEL FE 09210-01291
003. BODY ASSY, INJECTI 19010-00900
004. GOVERNOR ASSY, MEC 19080-05000

Scheme ###:

000. [01] 09200-01890 PUMP ASSY, INJECTI 32A6515040
005. [01] 19010-00900 BODY ASSY, INJECTI
006. [01] 19080-05000 GOVERNOR ASSY, MEC
007. [01] 09001-80081 COVER, CONTROL RAC 09001-80081
008. [01] 94905-03570 NUT, HEXAGON
009. [01] 94913-00300 KEY, WOODRUFF
010. [01] 94901-50590 WASHER, SPRING
012. [01] 09210-01291 PUMP ASSY, FUEL FE 34461-09060
013. [01] 91518-08221 BOLT, W/WASHER 91518-08221
014. [06] 91418-06161 BOLT, W/WASHER 91418-06161

Include in #3:

09200-01890 as PUMP ASSY, INJECTI

Cross reference number



Part num Firm num Firm Name
09200-01890  32A6515040  PUMP ASSY, INJECTI
32A6515040    MITSUBISHI PUMP ASSY, INJECTI




Information:


Indicates a condition that will cause death or serious injury if incorrect action is taken.
Indicates a condition that may cause death or serious injury if incorrect action is taken.
Indicates a condition that will cause engine damage or slight or moderate injury if incorrect action is taken.
Indicates a supplementary explanation or other important point.(6) With regard to tightening torques, points to which engine oil must be applied are labeled "Wet". Where there is no such indication, parts should be tightened in a dry condition.2. TerminologyTerms used in this manual are defined as follows:(1) Front and RearThe term "front" refers to the fan side of the engine, and the term "rear" applies to the flywheel side.(2) Left and RightThe terms "left" and "right" apply to the sides of the engine as seen from the flywheel.(3) Service Standards* Standard ValueThis term indicates a designed nominal dimension, the designed dimension of a single part, the standard clearance between two parts after assembly, or a standard performance value for an assembly.* LimitThis term indicates a value beyond which a part is no longer useable in terms of performance and strength and must be repaired or replaced.

Have questions with 09200-01890?





Group cross 09200-01890

Back to top