09200-01811 PUMP ASSY, INJECTI Denso Cross


 

Information pump assy, injecti

09200-01811 PUMP ASSY, INJECTI
Rating:
5
Buy PUMP ASSY, INJECTI 09200-01811 genuine, new aftermarket engine parts with delivery

Components :

001. PUMP ASSY, INJECTI 09200-01811
002. GOVERNOR ASSY, MEC 09130-05681
003. LEVER SET 09129-10470
004. COMPENSATOR SUB-AS 19260-00870
005. COMPENSATOR SUB-AS 19260-01040
006. TIMER ASSY, AUTOMA 09180-03760
007. PUMP ASSY, FUEL FE 09210-03100
007. PUMP ASSY, FUEL FE 09210-03100
008. BODY ASSY, INJECTI 19010-00980

Scheme ###:

000. [01] 09200-01811 PUMP ASSY, INJECTI 22100-5C350
003. [01] 19010-00980 BODY ASSY, INJECTI
004. [01] 09210-03100 PUMP ASSY, FUEL FE 22510-5C350
005. [01] 09130-05681 GOVERNOR ASSY, MEC 22410-5C350
006. [02] 94904-76880 BOLT, W/WASHER 90099-04481
007. [01] 94904-76900 BOLT, W/WASHER 90099-04483
008. [01] 94904-76910 BOLT, W/WASHER 90099-04484
009. [04] 94904-76890 BOLT, W/WASHER 90099-04482
010. [01] 09002-10040 KEY, WOODRUFF 22353-5C350
011. [01] 09001-20340 NUT, TIMER ROUND 22611-5C350
012. [01] 94901-81550 WASHER, COPPER PLA 23338-54020
013. [01] 09001-80471 COVER, CONTROL RAC 22116-5C350
016. [01] 09028-50050 CAP
017. [01] 09028-50030 CAP
017. [02] 09028-50030 CAP
018. [01] 09039-10040 CLIP, CORD 22568-68210
050. [01] 09180-03761 TIMER ASSY, AUTOMA 22610-58350

Include in #3:

09200-01811 as PUMP ASSY, INJECTI

Cross reference number



Part num Firm num Firm Name
09200-01811  22100-5C35  PUMP ASSY, INJECTI




Information:

1.2 Engine Model and Engine Serial Number(1) The engine model code is embossed next to the injection pump on the right-hand side of the cylinder block.
Engine model and total displacement(2) The engine serial number is shown by a label attached to the top of the rocker cover. It is also stamped on the injection pump mounting surface of the cylinder block.(3) The engine serial number is stamped as shown below:
Location of engine serial number label1.3 Engine Model and Application Codes(1) The engine model code is designated as shown below.* Engine model and classification * Model code 2. Specifications
2.1 Major Specifications 3. Points to Note for Disassembly and Reassembly
This service manual contains recommended service procedures for your Mitsubishi diesel engine. It also contains information on special tools and basic safety precautions. Since hazards exist in many places, the safety precautions in this manual should not be considered exhaustive. It is your responsibility to exercise common sense and to pay attention to safety at all times.Always perform service operations in accordance with this manual. When performing disassembly and reassembly operations, also observe the general instructions given below.3.1 Disassembly(1) Use only the correct tools and instruments.(2) Use an overhaul stand or work bench if necessary, and make ready a surface where removed parts can be arranged. Remove parts in the specified disassembly sequence.(3) Arrange disassembled parts neatly to avoid losing them.(4) Pay attention to alignment and position marks. If necessary, make your own marks to facilitate reassembly.(5) Carefully check parts for abnormalities when removing or cleaning them. Abnormalities may be harder to see after parts have been removed or cleaned.(6) Strive to ensure safety at all times. It is particularly important to make sure that items being disassembled are properly balanced and to pay attention to safety when moving heavy items. Use jacks and chain blocks when necessary.3.2 Reassembly(1) Wash all engine parts (except oil seals, O-rings, and rubber seals) in cleaning solvent and dry them with compressed air.(2) Use only the correct tools and instruments.(3) Use only high-quality oils and greases of the specified types. Be sure to apply a coat of oil, grease, or sealant wherever specified.(4) Use a torque wrench to achieve all specified tightening torques.(5) As a general rule, all gaskets and seals must be replaced with new ones. Apply adhesive where required, and be careful not to apply too much.

Have questions with 09200-01811?





Group cross 09200-01811

Back to top