09200-01530 ASSY Nzl Denso Cross


 

Information assy nzl

Nozzle: 0935005970
09200-01530 ASSY Nzl
Rating:
23
Buy ASSY Nzl 09200-01530 genuine, new aftermarket engine parts with delivery

KIT List:

Governor assy, mec 1908900271
Timer assy, automa No Application
Pump assy, fuel fe 1922900060
Body assy, injecti No Application

Components :

001. PUMP ASSY, INJECTI 09200-01530
002. GOVERNOR ASSY, MEC 09130-05390
003. LEVER SET 09129-10381
004. LEVER SET 09129-10500
005. COVER ASSY, GOVERN 09145-00920
006. TIMER ASSY, AUTOMA 09180-03580
007. PUMP ASSY, FUEL FE 09210-02870
008. COUPLING ASSY 09250-01080
009. BODY ASSY, INJECTI 19010-00690

Cross reference number



Part num Firm num Firm Name
09200-01530    ASSY Nzl
22010-7643    HINO PUMP ASSY, INJECTI
S2201-07643    HINO PUMP ASSY, INJECTI




Information:

Start By:a. remove timing gear coverb. remove fuel injection pump housing and governor 1. Remove four bolts (2), plate (3) and idler gear (1). 2. If the camshaft is not going to be removed, use Tool (A) to remove camshaft gear (4).
Do not turn the crankshaft with the camshaft gear removed. Damage can be caused to the pistons and valves or both.
3. Remove bolts (5) that hold timing gear plate (6) to the cylinder block.4. Remove timing gear plate (6). 5. Use Tool (B) to remove the bearing from the idler gear. The following steps are for the installation of the timing gears and plate.6. Install a new gasket on the timing gear plate.7. Put timing gear plate (6) in position on the cylinder block and install the bolts that hold the timing gear plate to the cylinder block.8. Heat camshaft gear (4) to a maximum temperature of 205° C (400° F) for no longer than three hours and install it on the camshaft.9. Use Tool (B) and install the bearing in the idler gear. Set the gear on the front face (face with the timing marks). Drive the bearing from the rear face toward the front face of the gear. Install the bearing to a depth of 1.5 0.5 mm (.06 .02 in) below the rear face of the idler gear.10. Install the idler gear, plate and bolts. Be sure No. 1 cylinder is at top center on the compression stroke. Install the idler gear so "V" mark (7) on the idler gear is in alignment with the "V" mark on the crankshaft gear. "K" marks (8) on the camshaft gear can be seen at the outer edges of the idler gear.End By:a. install fuel injection pump housing and governorb. install timing gear cover

Have questions with 09200-01530?





Group cross 09200-01530

Back to top