Information lever set
Rating:
Scheme ###:
| 000. | [01] | 09129-10070 | LEVER SET | ME728747 |
| 002. | [02] | 09083-50120 | COLLAR | ME728559 |
| 003. | [01] | 09083-50111 | COLLAR | ME728558 |
| 004. | [02] | 94901-38960 | WASHER, PLATE, SK | |
| 005. | [01] | 90557-06001 | RING, SHAFT SNAP | ME022207 |
Include in #3:
Cross reference number
| Part num | Firm num | Firm | Name |
| 09129-10070 | ME728747 | LEVER SET | |
| ME728747 | MITSUBISHI | LEVER SET |
Information:
941B 80H3884-Up
(1) Remove the engine from the machine; see the Service Manual for the procedure. Put both engines, new and old, in a position that will give good access to their front, rear, top and both sides. For those engines that were equipped with glow plugs, either remove the wire from the heat-start switch to the glow plug lead assembly, or put tape over the end of the wire when it is disconnected. This wire will not be needed because the new engine does not have glow plugs.(2) From the old engine, remove the crankshaft pulley and hub, engine front support, the rear supports (from the sides of the flywheel housing) and the flywheel. Install these
(1) Remove the engine from the machine; see the Service Manual for the procedure. Put both engines, new and old, in a position that will give good access to their front, rear, top and both sides. For those engines that were equipped with glow plugs, either remove the wire from the heat-start switch to the glow plug lead assembly, or put tape over the end of the wire when it is disconnected. This wire will not be needed because the new engine does not have glow plugs.(2) From the old engine, remove the crankshaft pulley and hub, engine front support, the rear supports (from the sides of the flywheel housing) and the flywheel. Install these