09000-09481 PUMP ASSY, INJECTI Denso Cross


 

Information pump assy, injecti

09000-09481 PUMP ASSY, INJECTI
Rating:
1
Buy PUMP ASSY, INJECTI 09000-09481 genuine, new aftermarket engine parts with delivery

Components :

001. PUMP ASSY, INJECTI 09000-09481
002. BODY ASSY, INJECTI 09010-02772
003. GOVERNOR ASSY, MEC 09080-04040
004. PUMP ASSY, FUEL FE 09210-00830

Scheme ###:

000. [01] 09000-09481 PUMP ASSY, INJECTI 31860-95010
005. [01] 09010-02772 BODY ASSY, INJECTI 31860-99012
006. [01] 09080-04040 GOVERNOR ASSY, MEC 31860-86060
007. [01] 09001-80081 COVER, CONTROL RAC ME702034
008. [01] 90801-30700 O-RING ME728818
009. [01] 09006-00031 COVER SUB-ASSY, TI
010. [01] 09185-10130 GEAR, TIMER DRIVIN 09185-10130
011. [04] 94905-02680 NUT, HEXAGON ME702046
012. [04] 90258-10001 WASHER, SPRING MC327716
013. [04] 94901-15020 WASHER, STEEL PLAT MH005068
014. [01] 09009-20100 BRACKET ME702036
015. [01] 94913-00050 KEY, WOODRUFF ME702747
016. [01] 94901-50500 WASHER, SPRING ME008373
017. [01] 09001-20200 NUT, TIMER ROUND
018. [01] 09210-00830 PUMP ASSY, FUEL FE 31860-99020
019. [01] 91518-08221 BOLT, W/WASHER MM500963
020. [06] 94900-50191 SCREW, SLOTTED FLA ME022439

Include in #3:

09000-09481 as PUMP ASSY, INJECTI

Cross reference number



Part num Firm num Firm Name
09000-09481  31860-9501  PUMP ASSY, INJECTI




Information:


The clutch warning sign is located on the clutch housing (if equipped).
Clutch warning sign.
Rotating gears- finger or hand entanglement. Do not service until reading the operator's manual.
Located near batteries (if equipped):
Improper jumper cable connections can cause an explosion resulting in personal injury.Batteries may be located in separate compartments. When using jumper cables, always connect positive (+) cable to positive (+) terminal of battery connected to starter solenoid and negative (-) cable from external source to starter negative (-) terminal (if machine not equipped with starter negative terminal, connect to engine block.) Follow procedure in the operation manual.
Located on the mounting base (if equipped) near the lifting holes:
Improper lift rigging can allow load to tumble causing injury and damage.
Located on the fuel tank (if equipped):
Drain fuel tank before lifting unit. Lifting this unit when fuel is present in the tank could result in separation of the tank from the base and cause personal injury or death.
Located on engine lifting eye cover assembly.
Do not use the engine lifting eyes to remove the engine and generator together.
Located on the side panels of the generator (if equipped):
Do not connect generator to a utility electrical distribution system unless it is isolated from the system. Electrical feedback into the distribution system can occur and could cause personal injury or death.Open and secure main distribution system switch. Or if the connection is permanent, install a double throw transfer switch to prevent electrical feedback. Some generators are specifically approved by a utility to run in parallel with the distribution system and isolation may not be required. Always check with your utility as to the applicable circumstances.
Located on the outside of the control panel vandal door (if equipped):
Always operate this unit with the vandal door open. Operating the unit with the vandal door closed restricts access to the emergency stop button and could result in injury or death.
Located on the outside of the control panel vandal door (if equipped), above the emergency stop warning:
Do not operator or work on this engine or generator set unless you have read and understand the instructions and warnings in the operation and maintenance manuals. Failure to follow the warnings and instructions could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Located inside the generator housing (if equipped):
Before working inside the generator, make sure that the starting motor can not be activated by any automatic or manual signal. When servicing or repairing electric power generation equipment make sure the unit is off-line (disconnected from utility and/or other generators power service), and either locked out or tagged DO NOT OPERATE. Remove all fuses. Make sure the generator engine is stopped. Make sure all batteries are disconnected. Make sure all capacitors are discharged. Failure to do so could result in personal injury or death. Make sure residual voltage in the rotor, stator and the generator is discharged.
General Hazard Information
Attach a DO NOT OPERATE or similar warning tag to the start switch or controls before performing maintenance

Have questions with 09000-09481?





Group cross 09000-09481

Back to top