Information pump assy, injecti
Nozzle:
0935000910
Rating:
KIT List:
| Body assy, injecti | 1904400300 |
| Governor assy, inj | 1908900260 |
| Pump assy, fuel fe | 1922900060 |
Components :
| 001. | PUMP ASSY, INJECTI | 09000-06870 |
| 002. | BODY ASSY, INJECTI | 09010-01971 |
| 003. | GOVERNOR ASSY, INJ | 09050-00412 |
| 004. | TIMER ASSY, AUTOMA | 09180-00340 |
| 005. | PUMP ASSY, FUEL FE | 09210-00402 |
Scheme ###:
| 000. | [01] | 09000-06870 | PUMP ASSY, INJECTI | 25710-40100-71 |
| 001. | [01] | 09010-01971 | BODY ASSY, INJECTI | |
| 002. | [01] | 09050-00412 | GOVERNOR ASSY, INJ | 25750-30170-71 |
| 003. | [01] | 09210-00402 | PUMP ASSY, FUEL FE | |
| 006. | [01] | 94913-00050 | KEY, WOODRUFF | |
| 007. | [01] | 94901-50490 | WASHER, SPRING | |
| 008. | [01] | 09001-20020 | NUT, TIMER ROUND | |
| 009. | [01] | 09257-50020 | SHAFT, SPLINE | |
| 010. | [04] | 91518-06161 | BOLT, W/WASHER | |
| 012. | [01] | 91518-08221 | BOLT, W/WASHER | |
| 015. | [01] | 09001-80061 | COVER, CONTROL RAC | |
| 016. | [01] | 09006-10011 | COVER, PRIMING PUM | |
| 017. | [01] | 09009-30012 | WIRE, OVER, INJECT | 22175-46010 |
| 020. | [01] | 09180-00340 | TIMER ASSY, AUTOMA |
Include in #3:
09000-06870
as PUMP ASSY, INJECTI
Cross reference number
| Part num | Firm num | Firm | Name |
| 09000-06870 | 25710-4010 | PUMP ASSY, INJECTI | |
| 25710-40100-71 | TICO | PUMP ASSY, INJECTI |
Information:
Ether is poisonous and flammable.Do not store replacement cylinders in living areas or in the operator's compartment.Do not smoke while changing ether cylinders.Use ether only in well ventilated areas.Use it with care to avoid fires.Keep the cylinders out of the reach of children.Avoid breathing of the ether vapors or repeated contact of ether with skin.Do not store cylinders in direct sunlight.Do not puncture or burn cylinders.Discard cylinders in a safe place.
The ether cylinder is located at the right front of the machine, inside the guard. 1. Remove the two bolts to open the guard. 2. Loosen the clamp (1). Unscrew the cylinder (2). 3. Remove the used gasket and replace it with the new one provided with each new cylinder. 4. Install a new cylinder and tighten it hand tight. Tighten the clamp.5. Close the guard and install the retaining bolts.
Remove the ether cylinder before shipping the machine.