159280-2700 ZEXEL 9 421 621 698 BOSCH CAM PLATE 9421621698 1592802700 1157299000


 

Information cam plate

BOSCH 9 421 621 698 9421621698
ZEXEL 159280-2700 1592802700
ISUZU 1157299000 1157299000
159280-2700 CAM PLATE
Rating:
45
Buy CAM PLATE 159280-2700 zexel genuine, new aftermarket engine parts with delivery

Include in ###:

Number on scheme 300
CAM PLATE
1059312464 as CAM PLATE

Cross reference number

Zexel num
Bosch num
Firm num
Name
159280-2700 
9 421 621 698 
1157299000  ISUZU
CAM PLATE
C 14GJ CAM PLATE GOV




Information:


Typical Example1. Remove bolts (1) and cover (2). Remove bolts (3) and cover (4).
Typical Example2. Remove bolts (5) and adapter (6). Be sure that gear stays in place. Remove bolts (7) and cover (8). Keep gear in place.
Typical Example3. Remove gears (9) and crankshaft gear (10). Remove bolts (11) and idler gear (12) with retainer. Remove bolts (13) and idler gear (14) with retainer.
Typical Example4. Secure strap and a hoist to housing (15). Remove hose assembly (16) and small bolts (17) and large bolts (18). 5. Remove bolts (19) that connect housing to oil pan (20). Remove housing from cylinder block. The weight of housing is approximately 105 kg (230 lb). 6. Check O-ring seal (21) and bearing (22) on adapter and replace if necessary. 7. Check bearing (23) and O-ring seal (24) on cover and replace if necessary. 8. Remove retainer (25) from gear (9) and check bearings (26) and replace if necessary. The following steps are for the installation of the flywheel housing.9. Thoroughly clean the contact surfaces of the cylinder block and flywheel housing. Install a new gasket between the flywheel housing and the cylinder clock.10. Secure strap and a hoist to the flywheel housing, put flywheel housing in position on the cylinder block. 11. Install the bolts that hold the flywheel housing to the cylinder block. Tighten bolts 1 thru 22 in number sequence to a torque of 40 10 N m (30 7 lb ft). Tighten bolts 1 thru 9 in number sequence again to a torque of 135 20 N m (100 15 lb ft). Tighten bolts 10 thru 22 in number sequence again to a torque of 55 10 N m (40 7 lb ft).12. Install bolts that connect housing to oil pan.13. Cut flywheel housing gasket off even with the cylinder block surface. Remove excess sealant.End By:a. install crankshaft rear seal and wear sleeveb. install starting motor

Have questions with 159280-2700?





Group cross 159280-2700 ZEXEL

Isuzu 

159280-2700  
9 421 621 698 
1157299000 
CAM PLATE
Back to top