159590-7621 ZEXEL 9 421 614 605 BOSCH ADJUSTING DEVICE 9421614605 1595907621 227101301a


 

Information adjusting device

BOSCH 9 421 614 605 9421614605
ZEXEL 159590-7621 1595907621
HINO 227101301A 227101301a
159590-7621 ADJUSTING DEVICE
Rating:
18
Buy ADJUSTING DEVICE 159590-7621 zexel genuine, new aftermarket engine parts with delivery

Scheme ###:

1. [1] 159595-3821 DIAPHRAGM HOUSING
2. [4] 159596-2800 BLEEDER SCREW
3. [1] 159595-9800 SEAL RING
5. [1] 131420-0400 BLEEDER SCREW
6. [1] 026506-1040 GASKET D9.9&6.2T1
8. [2] 139514-0300 GASKET
9. [1] 029731-4680 EYE BOLT
15. [1] 159594-8620 ACTUATOR
16. [1] 159596-5800 SEAL RING
17. [4] 010206-3040 HEX-SOCKET-HEAD CAP SCREW M6P1L30
17. [4] 010206-3040 HEX-SOCKET-HEAD CAP SCREW M6P1L30
18. [4] 029320-6010 LOCKING WASHER
18. [4] 029320-6010 LOCKING WASHER
19. [1] 139306-0400 PLAIN WASHER
20. [3] 159595-5700 PLAIN WASHER
30. [2] 159911-1100 CLAMPING BAND
31. [1] 159597-1000 CLAMPING BAND
804S. [1] 159911-4500 PLUG HOUSING

Include in #1:

Cross reference number

Zexel num
Bosch num
Firm num
Name
159590-7621 
159590-7622 
9 421 614 605 
227101301A  HINO
ADJUSTING DEVICE
* K




Information:

Startability will be improved at temperatures below +32°F (0°C) by the use of a starting aid and/or use of a cylinder block coolant heater or other means to heat the crankcase oil.Start the engine using the following procedure:1. Place the transmission in NEUTRAL and disengage the flywheel clutch (if equipped) to remove the transmission drag and prevent movement of the truck. Depressing the clutch in cold weather can mean the difference between starting and not starting. Depressing the clutch in warm weather produces faster starts and reduces battery drain.2. Turn the ignition switch to the ON position and push the crank button or turn the ignition switch to the START position. Crank the engine. (At temperatures below +32°F (0°C), it may be necessary to spray starting fluid into the air cleaner inlet.) DO NOT PUSH DOWN OR HOLD THE THROTTLE DOWN while cranking the engine. The PEEC system will automatically provide the correct amount of fuel to start the engine. The PEEC equipped engine may need to crank slightly longer than a mechanically governed engine, because some oil pressure is required for the electronic actuator to move the rack. The "CHECK ENGINE" light should be ON while the engine is cranking, but should go OFF after engine oil pressure is achieved.If the engine fails to start in 30 seconds, release the starter switch and wait two minutes to allow the starter motor to cool before using it again.
When using starting fluid, follow the manufacturer's instructions carefully, use it sparingly and spray it only while cranking the engine. Also, do not store starting fluid containers in the cab. Failure to do so, could result in an explosion and/or fire and possible personal injury.
Excessive ether can cause piston and ring damage. Use ether for cold starting purposes only.
3. As soon as the engine starts, allow the engine to idle for two or three minutes, or until the water temperature gauge indicator has begun to rise.4. Do not apply load to the engine or increase engine speed until the oil pressure gauge indicates normal. Oil pressure should rise within 15 seconds after the engine starts.5. Operate the engine at low load until all systems reach operating temperature. Check all gauges during the warm-up period.Starting With Jumper Cables
Batteries give off flammable fumes that can explode. Improper jumper cable connections can cause an explosion resulting in personal injury.Prevent sparks near the batteries. Sparks could cause vapors to explode. Do not allow jumper cable ends to contact each other or the engine.Do not smoke when observing the battery electrolyte levels.Always wear protective glasses when working with batteries.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.
Engines installed without engine-to-frame ground straps can be damaged by electrical discharge.To prevent electrical discharge damage, check to make sure the engine's electrical system has an engine-to-frame ground strap. For engines which have the alternator connected to an engine component, the ground strap must connect that component to the frame.Some engines have starter-to-frame

Have questions with 159590-7621?





Group cross 159590-7621 ZEXEL

Hino 

 
227101300A 
ADJUSTING DEVICE
159590-7621  

159590-7622 
9 421 614 605 
227101301A 
ADJUSTING DEVICE
F 01G 29N 0LZ 
 
ADJUSTING DEVICE
Back to top