159590-1621 ZEXEL 9 421 616 742 BOSCH ADJUSTING DEVICE 9421616742 1595901621 me727966


 

Information adjusting device

BOSCH 9 421 616 742 9421616742
ZEXEL 159590-1621 1595901621
MITSUBISHI ME727966 me727966
159590-1621 ADJUSTING DEVICE
Rating:
17
Buy ADJUSTING DEVICE 159590-1621 zexel genuine, new aftermarket engine parts with delivery

Scheme ###:

1. [1] 159595-0820 DIAPHRAGM HOUSING
2. [5] 159593-5800 BLEEDER SCREW
3. [1] 159596-5400 GASKET
8. [2] 029341-4130 GASKET D20&13.8T2*
9. [1] 029731-4680 EYE BOLT
15. [1] 159594-2821 ACTUATOR
16. [1] 159597-4700 SEAL RING
17. [4] 010206-2540 HEX-SOCKET-HEAD CAP SCREW M6P1L25
18. [4] 029320-6010 LOCKING WASHER
19. [4] 139306-0400 PLAIN WASHER
25. [1] 131420-0400 BLEEDER SCREW
26. [1] 026506-1040 GASKET D9.9&6.2T1
800S. [1] 159593-5500 GOVERNOR COVER
801S. [1] 159596-0100 SEAL RING
802S. [4] 010206-2540 HEX-SOCKET-HEAD CAP SCREW M6P1L25
803S. [4] 029320-6010 LOCKING WASHER
804S. [1] 159910-6800 PLUG HOUSING

Include in #1:

Cross reference number

Zexel num
Bosch num
Firm num
Name
159590-1621 
9 421 616 742 
ME727966  MITSUBISHI
ADJUSTING DEVICE
* K




Information:

Startability will be improved at temperatures below +32°F (0°C) by the use of a starting aid and/or use of a cylinder block coolant heater or other means to heat the crankcase oil.Start the engine using the following procedure:1. Place the transmission in NEUTRAL and disengage the flywheel clutch (if equipped) to remove the transmission drag and prevent movement of the truck. Depressing the clutch in cold weather can mean the difference between starting and not starting. Depressing the clutch in warm weather produces faster starts and reduces battery drain.2. Turn the ignition switch to the ON position and push the crank button or turn the ignition switch to the START position. Crank the engine. (At temperatures below +32°F (0°C), it may be necessary to spray starting fluid into the air cleaner inlet.) DO NOT PUSH DOWN OR HOLD THE THROTTLE DOWN while cranking the engine. The 3176 system will automatically provide the correct amount of fuel to start the engine. The engine may need to crank slightly longer than a mechanically governed engine, because some oil pressure is required for the electronic actuator to move the rack. The "CHECK ENGINE" light should beON while the engine is cranking, but should go OFF after the engine starts and operating oil pressure is achieved.If the engine fails to start in 30 seconds, release the starter switch and wait two minutes to allow the starter motor to cool before using it again.
When using starting fluid, follow the manufacturer's instructions carefully, use it sparingly and spray it only while cranking the engine. Also, do not store starting fluid containers in the cab. Failure todo so, could result in an explosion and/or fire and possible personal injury.
Excessive ether can cause piston and ring damage. Use ether for cold starting purposes only.
3. As soon as the engine starts, allow the engine to idle for two or three minutes, or until the water temperature gauge indicator has begun to rise.4. Do not apply load to the engine or increase engine speed until the oil pressure gauge indicates normal. Oil pressure should rise within 15 seconds after the engine starts.5. Operate the engine at low load until all systems reach operating temperature. Check all gauges during the warm-up period.Starting With Jumper Cables
Batteries give off flammable fumes that can explode.Improper jumper cable connections can cause an explosion resulting in personal injury.Prevent sparks near the batteries. Sparks could cause vapors to explode. Do not allow jumper cable ends to contact each other or the engine.Do not smoke when observing the battery electrolyte levels.Always wear protective glasses when working with batteries.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.
Engines installed without engine-to-frame ground straps can be damaged by electrical discharge.To prevent electrical discharge damage, check to make sure the engine's electrical system has an engine-to-frame ground strap. For engines which have the alternator connected to an engine component, the ground strap must connect that component to thframe.Some engines have starter-to-frame ground straps.

Have questions with 159590-1621?





Group cross 159590-1621 ZEXEL

Mitsubishi 

 
ME727168 
ADJUSTING DEVICE
159590-1621  
9 421 616 742 
ME727966 
ADJUSTING DEVICE
Back to top